lkml.org 
[lkml]   [2013]   [Aug]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4 1/2] staging: iio: Documentation sysfs-bus-iio add power_mode
On 08/16/13 13:12, Oleksandr Kravchenko wrote:
> Add description about in_accelX_power_mode and
> in_accel_power_mode_available.
>
Right now this is very much chip specific so it wants to go in
sysfs-bus-iio-accel-bma180 If / when it turns up in lots of parts
we can discuss whether it is a good general purpose interface
or not.


> Signed-off-by: Oleksandr Kravchenko <o.v.kravchenko@globallogic.com>
> ---
> Documentation/ABI/testing/sysfs-bus-iio | 10 ++++++++++
> 1 file changed, 10 insertions(+)
>
> diff --git a/Documentation/ABI/testing/sysfs-bus-iio b/Documentation/ABI/testing/sysfs-bus-iio
> index dda81ff..1a333f3 100644
> --- a/Documentation/ABI/testing/sysfs-bus-iio
> +++ b/Documentation/ABI/testing/sysfs-bus-iio
> @@ -792,3 +792,13 @@ Contact: linux-iio@vger.kernel.org
> Description:
> This attribute is used to read the amount of quadrature error
> present in the device at a given time.
> +
> +What: /sys/.../iio:deviceX/in_accelX_power_mode
> +KernelVersion: 3.11
> +Contact: linux-iio@vger.kernel.org
> +Description:
> + Specifies the chip power mode.
> + low_noise: reduce noise level from ADC,
> + low_power: enable low current consumption.
> + For a list of available output power modes read
> + in_accel_power_mode_available.
>


\
 
 \ /
  Last update: 2013-08-17 21:41    [W:0.051 / U:0.332 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site