[lkml]   [2013]   [Jul]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH] pinctrl: msm: Add support for MSM TLMM pinmux
On 07/30/2013 06:01 PM, Hanumant Singh wrote:
> On 7/30/2013 2:22 PM, Stephen Warren wrote:
>> On 07/30/2013 03:10 PM, hanumant wrote:
>> ...
>>> We actually have the same TLMM pinmux used by several socs of a family.
>>> The number of pins on each soc may vary.
>>> Also a given soc gets used in a number of boards.
>>> The device tree for a given soc is split into the different boards that
>>> its in ie the boards inherit a common soc.dtsi but have separate dts.
>>> The boards for the same soc may use different pin groups for
>>> accomplishing a function, since we have multiple i2c, spi uart etc
>>> peripheral instances on a soc. A different instance of each of the above
>>> peripherals, can be used in different boards, utilizing different
>>> or subset of same pin groups.
>>> Thus I would need to have multiple C files for one soc, based on the
>>> boards that it goes into.
>> The pinctrl driver should be exposing the raw capabilities of the HW.
>> All the board-specific configuration should be expressed in DT. So, the
>> driver shouldn't have to know anything about different boards at
>> compile-time.
> I agree, so I wanted to keep the pin grouping information in DT, we
> already have a board based differentiation of dts files in DT, for the
> same soc.

That's the opposite of what I was saying. Pin groups are a feature of
the SoC design, not the board.

 \ /
  Last update: 2013-07-31 02:41    [W:0.217 / U:0.112 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site