lkml.org 
[lkml]   [2013]   [Jul]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: Re: libata / IDE cs5536: 80c cable detect issue (and worse?)
Date

Hi,

On Thursday, July 18, 2013 08:25:41 PM Andreas Mohr wrote:
> Hi,
>
> forgot to mention that I had already added a libata.force=40c boot
> after my 80c config issue discovery
> which did successfully cause the "limiting to UDMA/33 due to 40c foo" dmesg
> yet where there's now initial but strong confirmation via reports
> that the resulting UDMA/33 limit did NOT manage to fix corruption issues,
> thus it's more strongly likely that the "bound to ill-suited pata_amd driver"
> (due to incorrectly configuring speeds, or due to not configuring speeds
> at all due to possibly BIOS not providing emulation of PCI register accesses
> to Geode bus, which would be properly supported by pata_cs5536 OTOH)
> thing is the actual reason and might fix it (fingers crossed).

UDMA/66 (and higher) requires 80-wire cable to work (if the vendor states
that UDMA/66 is supported then UDMA/100 should also work on CS5536). UDMA/33
should work just fine with 40-wire cable. Therefore this indeed sounds more
like wrong driver being selected issue than a cable problem.

Best regards,
--
Bartlomiej Zolnierkiewicz
Samsung R&D Institute Poland
Samsung Electronics



\
 
 \ /
  Last update: 2013-07-19 13:21    [W:0.085 / U:0.484 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site