lkml.org 
[lkml]   [2013]   [Jul]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCHv4 2/3] drivers: spi: Add qspi flash controller
Hi Mark,
On Thursday 18 July 2013 08:12 PM, Mark Brown wrote:
> On Thu, Jul 18, 2013 at 04:31:58PM +0300, Felipe Balbi wrote:
>> On Thu, Jul 18, 2013 at 02:18:22PM +0100, Mark Brown wrote:
>>> So why do we report that we handled the interrupt then? Shouldn't we at
>>> least warn if we're getting spurious IRQs?
>> not spurious. OMAP has two sets of IRQ status registers. One is call
>> IRQSTATUS$n (n = 0, 1, ...) and IRQSTATUS_RAW$n.
>> IRQSTATUS$n will only enable the bits which fired IRQs and aren't
>> masked while IRQSTATUS_RAW$n will also enable the bits which are masked.
>> I could never come up with a use case where we would need to handle IRQs
>> which we decided to mask, but perhaps there might be some cases, I don't
>> know.
>> Based on that, I believe Sourav is reading IRQSTATUS_RAW$n, then he need
>> to clear the masked bits.
> That's not the issue - the issue is that if none of the unmasked
> interrupts are being asserted we shouldn't be in the interrupt handler
> in the first place but the driver silently accepts that and reports that
> it handled the interrupt.
I believe this is what you hinted at doing..

there is a QSPI_INTR_STATUS_ENABLED_CLEAR register, which indicated the
interrupt
status.
if nothing is set in the above register, I should return IRQ_NONE.


\
 
 \ /
  Last update: 2013-07-18 17:41    [W:0.170 / U:0.260 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site