lkml.org 
[lkml]   [2013]   [Jun]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [RFC PATCH 0/4] watchdog: at91sam9_wdt: handle already configured wdt
Date


> -----Original Message-----
> From: linux-arm-kernel [mailto:linux-arm-kernel-bounces@lists.infradead.org]
> On Behalf Of Boris BREZILLON
> Sent: 2013年6月11日 18:51
> To: Wim Van Sebroeck; Jean-Christophe Plagniol-Villard; Ferre, Nicolas;
> linux-watchdog@vger.kernel.org
> Cc: devicetree-discuss@lists.ozlabs.org; linux-doc@vger.kernel.org;
> linux-kernel@vger.kernel.org; linux-arm-kernel@lists.infradead.org; Boris
> BREZILLON
> Subject: [RFC PATCH 0/4] watchdog: at91sam9_wdt: handle already configured
> wdt
>
> Hello,
>
> This patch series is a porposal to enhance the sam9 watchdog timer support.
>
> The at91sam9 watchdog timer cannot configured twice, and the current
> implementation only tries to configure in a static way:
> - 2 seconds timeout
> - wdt restart every 500ms
>
> If the timer has already been configured with different values, it returns an
> error and do not create any watchdog device.
>
> This is not critical if the watchdog is disabled, but if it has been enabled with
> different timeout values it will lead to a SoC reset.
>
> This patch series tries to address this issue by adapting the heartbeat value
> according the WDT timer config:
> - it first tries to configure the timer as requested.
> - if it fails it fallbacks to the current config, adapting its heartbeat timer
> to the needs
>
> This patch series also move to a dynamically allocated at91wdt device instead
> of the static instance. I'm not sure this is the best solution, so please tell
> me if you prefer to keep static instance of watchdog.
>
> It adds a new at91 wdt type: software. This new type make use of the at91 wdt
> interrupt to trigger a software watchdog.
>
> Finally it adds several properties to the device tree bindings.
>
> Best Regards,
> Boris
>
> Boris BREZILLON (4):
> watchdog: at91sam9_wdt: better watchdog support
> watchdog: at91sam9_wdt: update device tree doc
> ARM: at91/dt: add sam9 watchdog default options to SoCs
> ARM: at91/dt: add watchdog properties to kizbox board
>
> .../devicetree/bindings/watchdog/atmel-wdt.txt | 30 +-
> arch/arm/boot/dts/at91sam9260.dtsi | 5 +
> arch/arm/boot/dts/at91sam9263.dtsi | 5 +
> arch/arm/boot/dts/at91sam9g45.dtsi | 5 +
> arch/arm/boot/dts/at91sam9n12.dtsi | 5 +
> arch/arm/boot/dts/at91sam9x5.dtsi | 5 +
> arch/arm/boot/dts/kizbox.dts | 6 +
> arch/arm/boot/dts/sama5d3.dtsi | 5 +
> drivers/watchdog/at91sam9_wdt.c | 319
> +++++++++++++++-----
> 9 files changed, 300 insertions(+), 85 deletions(-)
>
> --
> 1.7.9.5
>
>
Tested on sama5d34ek, at91sam9g25ek, linux-next_20130620

Tested by Wenyou Yang <Wenyou.yang@atmel.com>


> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
\
 
 \ /
  Last update: 2013-06-21 04:41    [W:0.122 / U:0.976 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site