lkml.org 
[lkml]   [2013]   [Jun]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] cpufreq: ondemand: Change the calculation of target frequency
On 06/01/2013 05:56 PM, Viresh Kumar wrote:
> On 31 May 2013 22:03, Stratos Karafotis <stratosk@semaphore.gr> wrote:
>> On 05/31/2013 11:51 AM, Viresh Kumar wrote:
>>> I believe you should have removed other users of getavg() in a separate
>>> patch and also cc'd relevant people so that you can some review comments
>>> from them.
>>
>> I will split the patch in two. If it's OK, I will keep the removal of
>> __cpufreq_driver_getavg in the original patch and move the clean up of
>> APERF/MPERF support in a second patch. I will also cc relevant people.
>
> Even removal of __cpufreq_driver_getavg() should be done in a separate
> patch, so that it can be reverted easily if required later.

Thanks, Viresh. I will do the removal of that function in a seperate patch.
Should I use a third patch for it? Or should I include it in the patch which
will remove APERF/MPERF support?

>>> "Proportional to load" means C * load, so why is "policy->max / 100" *the* right C?
>>
>> I think, finally(?) I see your point. The right C should be "policy->cpuinfo.max_freq / 100".
>
> Why are you changing it to cpuinfo.max_freq?? This is fixed once a driver is
> initialized.. but user may request a lower max freq for a governor or policy.
> Which is actually reflected in policy->max I believe.

My initial thought is to have a linear function to calculate the target freq
proportional to load: (I will use 'C' as the function's slope as Rafael used it)

freq_target = C * load

For simplicity, let's assume that load is between 0 and 1 as initially is calculated
in governor.
Ideally, for a load = 0, we should have freq_target = 0 and for load = 1,
freq_target = cpuinfo.max

So, the slope C = cpuinfo.max

I think, it's matter of definition about what policy->min and policy->max can do.
Should they change the slope C? Or only limit freq_target?
I don't think that the policy->max (or min) should affect HOW (slope C) governor
calculates freq_target but only limit the calculated result.

Maybe, we could have separate tunables to a affect the slope C.

If I'm wrong about the definition of policy->min, policy->max, I would change
the code accordingly.


> Over that why keeping following check is useful anymore?
>
> if (load_freq > od_tuners->up_threshold)
> goto max.
>
> As, if load is over 95, then even policy->max * 95 / 100 will even give almost
> the same freq.
>

I thought that too. But maybe user selects a lower value for up_threshold.
(For example, up_threshold = 60). In my opinion, we have to keep up_theshold,
to give the possibility to user to have max freq with small loads.


Thanks for your comments!
Stratos


\
 
 \ /
  Last update: 2013-06-01 18:41    [W:0.128 / U:1.092 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site