lkml.org 
[lkml]   [2013]   [Jun]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/2 RESEND] gpio: samsung: Remove OF support for s3c24xx
Date
From: Sylwester Nawrocki <s.nawrocki@samsung.com>

There is no users of this code and there is already a pinctrl
driver written for s3c24xx which is going to be used on any
s3c24xx DT platforms. Hence this has been effectively a dead
code in mainline.

This reverts commit 172c6a13653ac8cd6a231293b87c93821e90c1d6
gpio: samsung: add devicetree init for s3c24xx arches

Cc: Heiko Stübner <heiko@sntech.de>
Signed-off-by: Sylwester Nawrocki <s.nawrocki@samsung.com>
Signed-off-by: Kyungmin Park <kyungmin.park@samsung.com>
Acked-by: Heiko Stuebner <heiko@sntech.de>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
---
This patch was supposed to be merged through the Samsung tree
(https://patchwork.kernel.org/patch/2450291) but it seem to
have slipped through the cracks.

.../devicetree/bindings/gpio/gpio-samsung.txt | 43 -------------
drivers/gpio/gpio-samsung.c | 63 --------------------
2 files changed, 0 insertions(+), 106 deletions(-)

diff --git a/Documentation/devicetree/bindings/gpio/gpio-samsung.txt b/Documentation/devicetree/bindings/gpio/gpio-samsung.txt
index f1e5dfe..5375625 100644
--- a/Documentation/devicetree/bindings/gpio/gpio-samsung.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio-samsung.txt
@@ -39,46 +39,3 @@ Example:
#gpio-cells = <4>;
gpio-controller;
};
-
-
-Samsung S3C24XX GPIO Controller
-
-Required properties:
-- compatible: Compatible property value should be "samsung,s3c24xx-gpio".
-
-- reg: Physical base address of the controller and length of memory mapped
- region.
-
-- #gpio-cells: Should be 3. The syntax of the gpio specifier used by client nodes
- should be the following with values derived from the SoC user manual.
- <[phandle of the gpio controller node]
- [pin number within the gpio controller]
- [mux function]
- [flags and pull up/down]
-
- Values for gpio specifier:
- - Pin number: depending on the controller a number from 0 up to 15.
- - Mux function: Depending on the SoC and the gpio bank the gpio can be set
- as input, output or a special function
- - Flags and Pull Up/Down: the values to use differ for the individual SoCs
- example S3C2416/S3C2450:
- 0 - Pull Up/Down Disabled.
- 1 - Pull Down Enabled.
- 2 - Pull Up Enabled.
- Bit 16 (0x00010000) - Input is active low.
- Consult the user manual for the correct values of Mux and Pull Up/Down.
-
-- gpio-controller: Specifies that the node is a gpio controller.
-- #address-cells: should be 1.
-- #size-cells: should be 1.
-
-Example:
-
- gpa: gpio-controller@56000000 {
- #address-cells = <1>;
- #size-cells = <1>;
- compatible = "samsung,s3c24xx-gpio";
- reg = <0x56000000 0x10>;
- #gpio-cells = <3>;
- gpio-controller;
- };
diff --git a/drivers/gpio/gpio-samsung.c b/drivers/gpio/gpio-samsung.c
index b22ca79..96f6a7c 100644
--- a/drivers/gpio/gpio-samsung.c
+++ b/drivers/gpio/gpio-samsung.c
@@ -933,67 +933,6 @@ static void __init samsung_gpiolib_add(struct samsung_gpio_chip *chip)
s3c_gpiolib_track(chip);
}

-#if defined(CONFIG_PLAT_S3C24XX) && defined(CONFIG_OF)
-static int s3c24xx_gpio_xlate(struct gpio_chip *gc,
- const struct of_phandle_args *gpiospec, u32 *flags)
-{
- unsigned int pin;
-
- if (WARN_ON(gc->of_gpio_n_cells < 3))
- return -EINVAL;
-
- if (WARN_ON(gpiospec->args_count < gc->of_gpio_n_cells))
- return -EINVAL;
-
- if (gpiospec->args[0] > gc->ngpio)
- return -EINVAL;
-
- pin = gc->base + gpiospec->args[0];
-
- if (s3c_gpio_cfgpin(pin, S3C_GPIO_SFN(gpiospec->args[1])))
- pr_warn("gpio_xlate: failed to set pin function\n");
- if (s3c_gpio_setpull(pin, gpiospec->args[2] & 0xffff))
- pr_warn("gpio_xlate: failed to set pin pull up/down\n");
-
- if (flags)
- *flags = gpiospec->args[2] >> 16;
-
- return gpiospec->args[0];
-}
-
-static const struct of_device_id s3c24xx_gpio_dt_match[] __initdata = {
- { .compatible = "samsung,s3c24xx-gpio", },
- {}
-};
-
-static __init void s3c24xx_gpiolib_attach_ofnode(struct samsung_gpio_chip *chip,
- u64 base, u64 offset)
-{
- struct gpio_chip *gc = &chip->chip;
- u64 address;
-
- if (!of_have_populated_dt())
- return;
-
- address = chip->base ? base + ((u32)chip->base & 0xfff) : base + offset;
- gc->of_node = of_find_matching_node_by_address(NULL,
- s3c24xx_gpio_dt_match, address);
- if (!gc->of_node) {
- pr_info("gpio: device tree node not found for gpio controller"
- " with base address %08llx\n", address);
- return;
- }
- gc->of_gpio_n_cells = 3;
- gc->of_xlate = s3c24xx_gpio_xlate;
-}
-#else
-static __init void s3c24xx_gpiolib_attach_ofnode(struct samsung_gpio_chip *chip,
- u64 base, u64 offset)
-{
- return;
-}
-#endif /* defined(CONFIG_PLAT_S3C24XX) && defined(CONFIG_OF) */
-
static void __init s3c24xx_gpiolib_add_chips(struct samsung_gpio_chip *chip,
int nr_chips, void __iomem *base)
{
@@ -1018,8 +957,6 @@ static void __init s3c24xx_gpiolib_add_chips(struct samsung_gpio_chip *chip,
gc->direction_output = samsung_gpiolib_2bit_output;

samsung_gpiolib_add(chip);
-
- s3c24xx_gpiolib_attach_ofnode(chip, S3C24XX_PA_GPIO, i * 0x10);
}
}

--
1.7.4.1
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2013-06-01 14:41    [W:0.061 / U:0.196 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site