lkml.org 
[lkml]   [2013]   [May]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: Fwd: [PATCH v7] i2c: exynos5: add High Speed I2C controller driver
On 2 May 2013 16:57, Wolfram Sang <wsa@the-dreams.de> wrote:
> Hi,
>
>> >> + - Samsung GPIO variant (deprecated):
>> >> + - gpios: The order of the gpios should be the following: <SDA, SCL>.
>> >> + The gpio specifier depends on the gpio controller.
>> >
>> > Huh? Why should we support a deprecated method with a new driver?
>> >
>
> This was left unanswered. I am curious.
This was a previous reply i sent out to public,
With my recent testing i can remove this deprecated method and use
pinctrl instead.
will be fixed in next revision.
>
>> >> +Optional properties:
>> >> + - samsung,hs-mode: Mode of operation, High speed or Fast speed mode. If not
>> >> + specified, default value is 0.
>> >> + - samsung,hs-clock-freq: Desired operating frequency in Hz of the bus.
>> >> + If not specified, the default value in Hz is 100000.
>> >> + - samsung,fs-clock-freq: Desired operarting frequency in Hz of the bus.
>> >> + If not specified, the default value in Hz is 100000.
>> >
>> > NACK! We have a generic binding for defining the bus speed. And
>> > shouldn't hs-mode be set depending on the bus speed?
>
> Please use "clock-frequency" here, like other drivers do.
I've tested this as well.
>
>> >> + /* In auto mode the length of xfer cannot be 0 */
>> >> + if (i2c->msg->len == 0)
>> >> + i2c_auto_conf |= 0x1;
>> >
>> > So you send some byte then? Why not reject the message?
>> This is to support the probing the devices (i2cdetect cases)
>
> No! This is not a proper SMBUS_QUICK if you send a byte! If it doesn't
> work without sending data, then your device does not support it. This is
> not uncommon. Please check the smbus specs if you are unsure.
Ok, i will look into it, thanks for pointing out.
With this fix, the i2cdetect works for me though.
>
>> >> + i2c->regs = of_iomap(np, 0);
>> >
>> > devm_ioremap_resource()
>> This was a comment from Thomas on v1.
>> https://lkml.org/lkml/2012/11/27/264
>>
>> Kindly, suggest me which one is more optimal in this case.
>
> "Optimal" is difficult here, but devm_* has momentum and I prefer
> consistency.
I've seen the rate of adaption for devm_* functions, have changed in
my local work.
>
>> Thanks for your valuable time and comments
>
> You're welcome! Thanks for the submission.
Thanks again.
Naveen
>
> Wolfram
>



--
Shine bright,
(: Nav :)


\
 
 \ /
  Last update: 2013-05-02 14:21    [W:1.270 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site