lkml.org 
[lkml]   [2013]   [May]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3] ARM:dts:omap4-panda:Update the LED support for the panda DTS
$subject - add a space?
s/ARM:dts:omap4-panda:Update/ARM: dts: omap4-panda: Update/ ?

On 09:17-20130514, Dan Murphy wrote:
> The GPIO for LED D1 on the omap4-panda a1-a3 rev and the omap4-panda-es
> are different.
>
> A1-A3 = gpio_wk7
Thanks for fixing this - this is a key fix else, GPIO_7 which controls
VSEL for VDD_MPU on PandaBoard-ES will create all kind of ruckus (change
voltage on heartbeat)!
> ES = gpio_110
>
> There is no change to LED D2
>
> Abstract away the pinmux and the LED definitions for the two boards into
> the respective DTS files.
>
> Signed-off-by: Dan Murphy <dmurphy@ti.com>
> ---
[...]
> diff --git a/arch/arm/boot/dts/omap4-panda-es.dts b/arch/arm/boot/dts/omap4-panda-es.dts
> index f1d8c21..8d1ba03 100644
> --- a/arch/arm/boot/dts/omap4-panda-es.dts
> +++ b/arch/arm/boot/dts/omap4-panda-es.dts
> @@ -34,3 +34,43 @@
> 0x5e 0x100 /* hdmi_sda.hdmi_sda INPUT | MODE 0 */
> >;
> };
> +
> +&leds {
> + compatible = "gpio-leds";
> + heartbeat {
> + label = "pandaboard::status1";
> + gpios = <&gpio4 14 0>;
> + linux,default-trigger = "heartbeat";
> + };
> + mmc {
> + label = "pandaboard::status2";
> + gpios = <&gpio1 8 0>;
> + linux,default-trigger = "gpio";
mmc0?
> + };
> +};
> +
Other that that,
Tested-by: Nishanth Menon <nm@ti.com>
--
Regards,
Nishanth Menon


\
 
 \ /
  Last update: 2013-05-15 08:01    [W:0.056 / U:0.384 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site