lkml.org 
[lkml]   [2013]   [Apr]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: RFC: IOMMU/AMD: Error Handling
On 4/29/2013 4:42 PM, Don Dutile wrote:
> On 04/29/2013 04:34 PM, Duran, Leo wrote:
>> I'm wondering if resetting the IOMMU at init-time (once) would clear
>> any BIOS induced noise.
>> Leo
>>
> Well, depends what you mean by 'reset'....
> (a) setting it up for OS use is effectively a reset, but doesn't
> quiesce a device
> doing dma reads of a (bios-setup) queue. then the noisy messages
> begin
> (b) disable the iommu, and then the dma just occurs... and bad for
> writes, potentially.
>
> Similar issue is being reported & worked for kdump, where device are
> still
> doing DMA while the system is trying to 'reset' to the kexec'd kernel,
> and
> take a crash dump.
>
> Solution: stop devices from doing dma... but some you _want_ enabled
> throughout...
> like keyboard & mouse via usb controller, so you get to pick
> os from
> grub... not so for kexec...
>
> so, again, for isolation faults.... let the hw do its job -- isolate
> and throttle/silence the fault messages on a per-device, time-duration
> heuristic
> so the system can get through boot-up where enough OS is init'd
> (drivers started)
> to stop the temporary noise.
This sounds more like issue with the order of how things are initialized
in the system.
If so, could we separate the code which enabling of IOMMU error
logging/handling and
delay it until we are certain that systems are stable?

Suravee



\
 
 \ /
  Last update: 2013-04-30 17:41    [W:0.055 / U:0.316 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site