lkml.org 
[lkml]   [2013]   [Apr]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] x86: add phys addr validity check for /dev/mem mmap
On 04/26/2013 11:35 PM, Frantisek Hrbata wrote:
> On Fri, Apr 26, 2013 at 01:21:28PM +0800, Will Huck wrote:
>> Hi Peter,
>> On 04/02/2013 08:28 PM, Frantisek Hrbata wrote:
>>> When CR4.PAE is set, the 64b PTE's are used(ARCH_PHYS_ADDR_T_64BIT is set for
>>> X86_64 || X86_PAE). According to [1] Chapter 4 Paging, some higher bits in 64b
>>> PTE are reserved and have to be set to zero. For example, for IA-32e and 4KB
>>> page [1] 4.5 IA-32e Paging: Table 4-19, bits 51-M(MAXPHYADDR) are reserved. So
>>> for a CPU with e.g. 48bit phys addr width, bits 51-48 have to be zero. If one of
>>> the reserved bits is set, [1] 4.7 Page-Fault Exceptions, the #PF is generated
>>> with RSVD error code.
>>>
>>> <quote>
>>> RSVD flag (bit 3).
>>> This flag is 1 if there is no valid translation for the linear address because a
>>> reserved bit was set in one of the paging-structure entries used to translate
>>> that address. (Because reserved bits are not checked in a paging-structure entry
>>> whose P flag is 0, bit 3 of the error code can be set only if bit 0 is also
>>> set.)
>>> </quote>
>>>
>>> In mmap_mem() the first check is valid_mmap_phys_addr_range(), but it always
>>> returns 1 on x86. So it's possible to use any pgoff we want and to set the PTE's
>>> reserved bits in remap_pfn_range(). Meaning there is a possibility to use mmap
>> In this case, remap_pfn_range() setup the map and reserved bits for
>> mmio memory, so the mmio memory is already populated, why trigger
>> #PF?
> Hi,
>
> I think this is described in the quote above for the RSVD flag.
>
> remap_pfn_range() => page present => touch page => tlb miss =>
> walk through paging structures => reserved bit set => #pf with rsvd flag

Page present can also trigger #PF? why?

>
> I hope I didn't misunderstand your question.
>
> Thanks
>
>>> on /dev/mem and cause system panic. It's probably not that serious, because
>>> access to /dev/mem is limited and the system has to have panic_on_oops set, but
>>> still I think we should check this and return error.
>>>
>>> This patch adds check for x86 when ARCH_PHYS_ADDR_T_64BIT is set, the same way
>>> as it is already done in e.g. ioremap. With this fix mmap returns -EINVAL if the
>>> requested phys addr is bigger then the supported phys addr width.
>>>
>>> [1] Intel 64 and IA-32 Architectures Software Developer's Manual, Volume 3A
>>>
>>> Signed-off-by: Frantisek Hrbata <fhrbata@redhat.com>
>>> ---
>>> arch/x86/include/asm/io.h | 4 ++++
>>> arch/x86/mm/mmap.c | 13 +++++++++++++
>>> 2 files changed, 17 insertions(+)
>>>
>>> diff --git a/arch/x86/include/asm/io.h b/arch/x86/include/asm/io.h
>>> index d8e8eef..39607c6 100644
>>> --- a/arch/x86/include/asm/io.h
>>> +++ b/arch/x86/include/asm/io.h
>>> @@ -242,6 +242,10 @@ static inline void flush_write_buffers(void)
>>> #endif
>>> }
>>> +#define ARCH_HAS_VALID_PHYS_ADDR_RANGE
>>> +extern int valid_phys_addr_range(phys_addr_t addr, size_t count);
>>> +extern int valid_mmap_phys_addr_range(unsigned long pfn, size_t count);
>>> +
>>> #endif /* __KERNEL__ */
>>> extern void native_io_delay(void);
>>> diff --git a/arch/x86/mm/mmap.c b/arch/x86/mm/mmap.c
>>> index 845df68..92ec31c 100644
>>> --- a/arch/x86/mm/mmap.c
>>> +++ b/arch/x86/mm/mmap.c
>>> @@ -31,6 +31,8 @@
>>> #include <linux/sched.h>
>>> #include <asm/elf.h>
>>> +#include "physaddr.h"
>>> +
>>> struct __read_mostly va_alignment va_align = {
>>> .flags = -1,
>>> };
>>> @@ -122,3 +124,14 @@ void arch_pick_mmap_layout(struct mm_struct *mm)
>>> mm->unmap_area = arch_unmap_area_topdown;
>>> }
>>> }
>>> +
>>> +int valid_phys_addr_range(phys_addr_t addr, size_t count)
>>> +{
>>> + return addr + count <= __pa(high_memory);
>>> +}
>>> +
>>> +int valid_mmap_phys_addr_range(unsigned long pfn, size_t count)
>>> +{
>>> + resource_size_t addr = (pfn << PAGE_SHIFT) + count;
>>> + return phys_addr_valid(addr);
>>> +}
>> --
>> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
>> the body of a message to majordomo@vger.kernel.org
>> More majordomo info at http://vger.kernel.org/majordomo-info.html
>> Please read the FAQ at http://www.tux.org/lkml/



\
 
 \ /
  Last update: 2013-04-27 09:21    [W:0.071 / U:0.124 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site