lkml.org 
[lkml]   [2013]   [Apr]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    SubjectRe: ahci driver cannot suspend a CF card, ata_piix can
    On 04/16/2013 07:58 PM, Boszormenyi Zoltan wrote:
    > Hi,
    >
    > The SATA interface can be switched between AHCI and legacy modes as usual:
    >
    > 00:1f.2 SATA controller: Intel Corporation NM10/ICH7 Family SATA
    > Controller [AHCI mode] (rev 02)
    >
    > The device attached to the SATA controller is always a CF card via a
    > SiI3811 Serial ATA to Parallel ATA Device Bridge based converter board.

    Can you please attach a normal sata disk and try again with the
    controller set to AHCI mode? I suspect it may be the SiI3811 bridge that
    caused this command.

    Thanks,
    Aaron



    \
     
     \ /
      Last update: 2013-04-19 18:01    [W:3.527 / U:1.468 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site