lkml.org 
[lkml]   [2013]   [Mar]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v4 06/21] ARM: OMAP3: 3630SDP: Adapt to ehci-omap changes
Date
Use usbhs_init_phys() to register the PHY's RESET regulators
and the NOP PHY devices.

Signed-off-by: Roger Quadros <rogerq@ti.com>
---
arch/arm/mach-omap2/board-3630sdp.c | 21 +++++++++++++++------
1 files changed, 15 insertions(+), 6 deletions(-)

diff --git a/arch/arm/mach-omap2/board-3630sdp.c b/arch/arm/mach-omap2/board-3630sdp.c
index 67447bd..20d6d81 100644
--- a/arch/arm/mach-omap2/board-3630sdp.c
+++ b/arch/arm/mach-omap2/board-3630sdp.c
@@ -53,16 +53,23 @@ static void enable_board_wakeup_source(void)
OMAP_WAKEUP_EN | OMAP_PIN_INPUT_PULLUP);
}

+static struct usbhs_phy_data phy_data[] __initdata = {
+ {
+ .port = 1,
+ .reset_gpio = 126,
+ .vcc_gpio = -EINVAL,
+ },
+ {
+ .port = 2,
+ .reset_gpio = 61,
+ .vcc_gpio = -EINVAL,
+ },
+};
+
static struct usbhs_omap_platform_data usbhs_bdata __initdata = {

.port_mode[0] = OMAP_EHCI_PORT_MODE_PHY,
.port_mode[1] = OMAP_EHCI_PORT_MODE_PHY,
- .port_mode[2] = OMAP_USBHS_PORT_MODE_UNUSED,
-
- .phy_reset = true,
- .reset_gpio_port[0] = 126,
- .reset_gpio_port[1] = 61,
- .reset_gpio_port[2] = -EINVAL
};

#ifdef CONFIG_OMAP_MUX
@@ -199,6 +206,8 @@ static void __init omap_sdp_init(void)
board_smc91x_init();
board_flash_init(sdp_flash_partitions, chip_sel_sdp, NAND_BUSWIDTH_16);
enable_board_wakeup_source();
+
+ usbhs_init_phys(phy_data, ARRAY_SIZE(phy_data));
usbhs_init(&usbhs_bdata);
}

--
1.7.4.1


\
 
 \ /
  Last update: 2013-03-20 18:01    [W:0.111 / U:1.776 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site