lkml.org 
[lkml]   [2013]   [Dec]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/2] Documentation: dt: Document TSC2005 DT binding
Date
Add devicetree binding documentation for TSC2005 touchscreen.

Signed-off-by: Sebastian Reichel <sre@debian.org>
---
.../bindings/input/touchscreen/tsc2005.txt | 49 ++++++++++++++++++++++
1 file changed, 49 insertions(+)
create mode 100644 Documentation/devicetree/bindings/input/touchscreen/tsc2005.txt

diff --git a/Documentation/devicetree/bindings/input/touchscreen/tsc2005.txt b/Documentation/devicetree/bindings/input/touchscreen/tsc2005.txt
new file mode 100644
index 0000000..4e7df0b
--- /dev/null
+++ b/Documentation/devicetree/bindings/input/touchscreen/tsc2005.txt
@@ -0,0 +1,49 @@
+* TSC2005 Touchscreen
+
+Required properties:
+ - compatible : "ti,tsc2005"
+ - reg : SPI device address
+ - spi-max-frequency : Maximal SPI speed
+ - interrupts : IRQ specifier
+ - reset-gpio : GPIO specifier
+
+Optional properties:
+ - ti,fuzz-x : integer, X noise value of the touchscreen
+ (defaults to 4)
+ - ti,fuzz-y : integer, Y noise value of the touchscreen
+ (defaults to 8)
+ - ti,fuzz-pressure : integer, pressure noise value of the touchscreen
+ (defaults to 2)
+ - ti,max-x : integer, maximum reported x value
+ (defaults to 4096)
+ - ti,max-y : integer, maximum reported y value
+ (defaults to 4096)
+ - ti,max-pressure : integer, maximum reported pressure
+ (defaults to 4096)
+ - ti,x-plate-resistance : integer, resistance of the touchscreen's X plates
+ in ohm (defaults to 280)
+ - ti,esd-recovery-timeout-ms : integer, if the touchscreen does not respond after
+ the configured time (in milli seconds), the driver
+ will reset it. This is disabled by default.
+
+Example:
+
+&mcspi1 {
+ tsc2005@0 {
+ compatible = "ti,tsc2005";
+ spi-max-frequency = <6000000>;
+ reg = <0>;
+ reset-gpio = <&gpio4 8 GPIO_ACTIVE_HIGH>; /* 104 */
+ interrupt-parent = <&gpio4>;
+ interrupts = <4 IRQ_TYPE_NONE>; /* gpio line 100 */
+
+ ti,fuzz-x = <4>;
+ ti,fuzz-y = <7>;
+ ti,fuzz-pressure = <2>;
+ ti,max-x = <4096>;
+ ti,max-y = <4096>;
+ ti,max-pressure = <2048>;
+ ti,x-plate-resistance = <280>;
+ ti,esd-recovery-timeout-ms = <8000>;
+ };
+}
--
1.8.4.3


\
 
 \ /
  Last update: 2013-12-06 00:21    [W:0.055 / U:1.744 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site