Messages in this thread | | | From | Laurent Pinchart <> | Subject | Re: [PATCH 1/2] regulator: gpio: Document regulator-type property | Date | Thu, 05 Dec 2013 21:08:59 +0100 |
| |
Hi Mark,
Thank you for the patch.
On Thursday 05 December 2013 19:12:01 Mark Brown wrote: > From: Mark Brown <broonie@linaro.org> > > Reported-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com> > Signed-off-by: Mark Brown <broonie@linaro.org> > --- > Documentation/devicetree/bindings/regulator/gpio-regulator.txt | 2 ++ > 1 file changed, 2 insertions(+) > > diff --git a/Documentation/devicetree/bindings/regulator/gpio-regulator.txt > b/Documentation/devicetree/bindings/regulator/gpio-regulator.txt index > 63c659800c03..aaf5f66e66fb 100644 > --- a/Documentation/devicetree/bindings/regulator/gpio-regulator.txt > +++ b/Documentation/devicetree/bindings/regulator/gpio-regulator.txt > @@ -10,6 +10,8 @@ Optional properties: > - gpios : GPIO group used to control voltage. > - startup-delay-us : Startup time in microseconds. > - enable-active-high : Polarity of GPIO is active high (default is low). > +- regulator-type : Specifies what is being regulated, must be either > + "voltage" or "current"
What about adding "The type defaults to voltage if unspecified." ?
> Any property defined as part of the core regulator binding defined in > regulator.txt can also be used.
-- Regards,
Laurent Pinchart
| |