Messages in this thread |  | | Date | Thu, 5 Dec 2013 09:11:28 +0800 | From | Bo Shen <> | Subject | Re: [PATCH v8 1/2] PWM: atmel-pwm: add PWM controller driver |
| |
Hi Thierry,
On 12/04/2013 06:03 PM, Thierry Reding wrote: > On Wed, Dec 04, 2013 at 10:59:46AM +0800, Bo Shen wrote: >> Hi Thierry, >> >> On 12/03/2013 05:43 PM, Thierry Reding wrote: >>> On Tue, Dec 03, 2013 at 11:09:12AM +0800, Bo Shen wrote: >>>> On 12/02/2013 06:59 PM, Thierry Reding wrote: >>>>> On Mon, Nov 18, 2013 at 05:13:21PM +0800, Bo Shen wrote: >>> [...] >>>>>> diff --git a/drivers/pwm/pwm-atmel.c b/drivers/pwm/pwm-atmel.c >>> [...] >>>>>> + /* Calculate the period cycles */ >>>>>> + while (div > PWM_MAX_PRD) { >>>>>> + div = clk_rate / (1 << pres); >>>>>> + div = div * period_ns; >>>>>> + /* 1/Hz = 100000000 ns */ >>>>> >>>>> I don't think that comment is needed. >>>> >>>> This is asked to be added. >>>> And, I think keep it and it won't hurt, what do you think? >>> >>> I think it's obvious that you're converting from nanoseconds because of >>> the _ns prefix in period_ns. But if somebody requested this and everyone >>> else thinks it's useful, I'm okay with keeping it. >>> >>>>>> + if (test_bit(PWMF_ENABLED, &pwm->flags)) { >>>>>> + atmel_pwm_ch_writel(atmel_pwm, pwm->hwpwm, PWMV2_CDTYUPD, dty); >>>>>> + } else { >>>>>> + atmel_pwm_ch_writel(atmel_pwm, pwm->hwpwm, PWMV2_CDTY, dty); >>>>>> + atmel_pwm_ch_writel(atmel_pwm, pwm->hwpwm, PWMV2_CPRD, prd); >>>>>> + } >>>>>> +} >>>>> >>>>> Neither version 1 nor version 2 seem to be able to change the period >>>>> while the channel is enabled. Perhaps that should be checked for in >>>>> atmel_pwm_config() and an error (-EBUSY) returned? >>>> >>>> The period is configured in dt in device tree, or platform data in non >>>> device tree. Nowhere will update period. So, not code to update period. >>>> Am I right? If not, please figure out. >>> >>> The .config() operation allows the period to be specified. Just because >>> nobody currently changes it at runtime doesn't mean it can't be done. >>> >>> It is also possible that whoever wrote the device tree or platform data >>> didn't know that the period must be the same for all PWM channels and >>> therefore might use different values. If you check for this, at least >>> they'll notice. If you don't check for it, then they may end up having >>> the period reconfigured behind their backs, which may cause parts of >>> their setup to behave unexpectedly. >> >> Thanks for this information. >> I will add code for changing period. > > Just to clarify: I wouldn't want this code to allow changing the period > but rather reject incompatible changes to the period with an error code.
So, in this patch, just check it as you suggested in previous email, would it be OK? --->8--- Perhaps that should be checked for in atmel_pwm_config() and an error (-EBUSY) returned? ---8<---
> Thierry
Best Regards, Bo Shen
|  |