Messages in this thread |  | | Date | Wed, 4 Dec 2013 10:10:50 +0000 | From | Graeme Gregory <> | Subject | Re: [RFC part1 PATCH 7/7] ARM64 / ACPI: Enable ARM64 in Kconfig |
| |
On Wed, Dec 04, 2013 at 12:36:51AM +0800, Hanjun Guo wrote: > Add Kconfigs to build ACPI on ARM64, and make ACPI runable on ARM64. > > acpi_idle driver is x86/IA64 dependent now, so make CONFIG_ACPI_PROCESSOR > depends on X86 || IA64, and implement it on ARM in the furture. > > In order to make arm-core.c can both run on ARM and ARM64, introduce > CONFIG_ACPI_ARM to support it. > > Signed-off-by: Graeme Gregory <graeme.gregory@linaro.org> > Signed-off-by: Al Stone <al.stone@linaro.org> > Signed-off-by: Hanjun Guo <hanjun.guo@linaro.org> > --- > arch/arm64/Kconfig | 2 ++ > drivers/acpi/Kconfig | 12 +++++++++--- > drivers/acpi/plat/Makefile | 2 +- > 3 files changed, 12 insertions(+), 4 deletions(-) > > diff --git a/arch/arm64/Kconfig b/arch/arm64/Kconfig > index 88c8b6c1..a37795f 100644 > --- a/arch/arm64/Kconfig > +++ b/arch/arm64/Kconfig > @@ -280,6 +280,8 @@ source "net/Kconfig" > > source "drivers/Kconfig" > > +source "drivers/acpi/Kconfig" > + > source "fs/Kconfig" > > source "arch/arm64/kvm/Kconfig" > diff --git a/drivers/acpi/Kconfig b/drivers/acpi/Kconfig > index 53f0f16..f43485e 100644 > --- a/drivers/acpi/Kconfig > +++ b/drivers/acpi/Kconfig > @@ -2,13 +2,17 @@ > # ACPI Configuration > # > > +config ACPI_ARM > + bool > + select ACPI_REDUCED_HARDWARE > + > menuconfig ACPI > bool "ACPI (Advanced Configuration and Power Interface) Support" > depends on !IA64_HP_SIM > - depends on IA64 || X86 > - depends on PCI > + depends on ((IA64 || X86) && PCI) || ARM64 > select PNP > - default y > + select ACPI_ARM if (ARM || ARM64) > + default y if !(ARM || ARM64)
Should only be ARM64 here with the current files in this series, I think this is causing others confusion looking for arm 32bit support in patches where there is none yet!
> help > Advanced Configuration and Power Interface (ACPI) support for > Linux requires an ACPI-compliant platform (hardware/firmware), > @@ -149,6 +153,7 @@ config ACPI_PROCESSOR > tristate "Processor" > select THERMAL > select CPU_IDLE > + depends on X86 || IA64 > default y > help > This driver installs ACPI as the idle handler for Linux and uses > @@ -250,6 +255,7 @@ config ACPI_DEBUG > config ACPI_PCI_SLOT > bool "PCI slot detection driver" > depends on SYSFS > + depends on PCI > default n > help > This driver creates entries in /sys/bus/pci/slots/ for all PCI > diff --git a/drivers/acpi/plat/Makefile b/drivers/acpi/plat/Makefile > index 46bc65e..3a61176 100644 > --- a/drivers/acpi/plat/Makefile > +++ b/drivers/acpi/plat/Makefile > @@ -1 +1 @@ > -obj-$(CONFIG_ARM64) += arm-core.o > +obj-$(CONFIG_ACPI_ARM) += arm-core.o > -- > 1.7.9.5 >
|  |