lkml.org 
[lkml]   [2013]   [Dec]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v6 6/6] ARM: davinci: da850 evm: add GPIO pinumux entries DT node
From
On Sun, Dec 15, 2013 at 2:13 PM, Sekhar Nori <nsekhar@ti.com> wrote:
> On Thursday 21 November 2013 11:45 PM, Prabhakar Lad wrote:
>> From: KV Sujith <sujithkv@ti.com>

>> +
>> + gpio_pins: pinmux_gpio_pins {
>> + pinctrl-single,bits = <
>> + /* GPIO2_4 GPIO2_6 */
>> + 0x18 0x00008080 0x0000f0f0
>> + /* GPIO2_8 GPIO2_15 */
>> + 0x14 0x80000008 0xf000000f
>> + /* GPIO3_12 GPIO3_13 */
>> + 0x1C 0x00008800 0x0000ff00
>> + /* GPIO4_0 GPIO4_1 */
>> + 0x28 0x88000000 0xff000000
>> + /* GPIO6_9 GPIO6_10 GPIO6_13 */
>> + 0x34 0x08800800 0x0ff00f00
>> + >;
>> + };
>> };
>
> Shouldn't these pinmux entries be part of actual device
> node which needs them to be muxed this way?

The usual way to do it is to set up as states for the device,
or as a hog (on the pin controller itself).

Yours,
Linus Walleij


\
 
 \ /
  Last update: 2013-12-17 11:41    [W:0.134 / U:0.404 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site