lkml.org 
[lkml]   [2013]   [Dec]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH] ARM: OMAP2+: omap_device: add fail hook for runtime_pm when bad data is detected
Date
Tony Lindgren <tony@atomide.com> writes:

> * Kevin Hilman <khilman@linaro.org> [131209 08:07]:
>> Tony Lindgren <tony@atomide.com> writes:
>>
>> > * Nishanth Menon <nm@ti.com> [131203 17:40]:
>> >> Due to the cross dependencies between hwmod for automanaged device
>> >> information for OMAP and dts node definitions, we can run into scenarios
>> >> where the dts node is defined, however it's hwmod entry is yet to be
>> >> added. In these cases:
>> >> a) omap_device does not register a pm_domain (since it cannot find
>> >> hwmod entry).
>> >> b) driver does not know about (a), does a pm_runtime_get_sync which
>> >> never fails
>> >> c) It then tries to do some operation on the device (such as read the
>> >> revision register (as part of probe) without clock or adequate OMAP
>> >> generic PM operation performed for enabling the module.
>> >>
>> >> This causes a crash such as that reported in:
>> >> https://bugzilla.kernel.org/show_bug.cgi?id=66441
>> >>
>> >> When 'ti,hwmod' is provided in dt node, it is expected that the device
>> >> will not function without the OMAP's power automanagement. Hence, when
>> >> we hit a fail condition (due to hwmod entries not present or other
>> >> similar scenario), fail at pm_domain level due to lack of data, provide
>> >> enough information for it to be fixed, however, it allows for the driver
>> >> to take appropriate measures to prevent crash.
>> >
>> > Kevin, any comments on this one?
>>
>> Looks like a good approach to catch these corner cases.
>>
>> Acked-by: Kevin Hilman <khilman@linaro.org>
>
> Kevin, care to apply this directly?
>
> Acked-by: Tony Lindgren <tony@atomide.com>

Applied.

Kevin


\
 
 \ /
  Last update: 2013-12-11 07:41    [W:0.084 / U:0.096 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site