lkml.org 
[lkml]   [2013]   [Nov]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] net: mv643xx_eth: Add missing phy_addr_set in DT mode
On 11/05/2013 11:12 PM, Arnaud Ebalard wrote:
> Hi Jason,
>
> Jason Gunthorpe <jgunthorpe@obsidianresearch.com> writes:
>
>> Commit cc9d4598 'net: mv643xx_eth: use of_phy_connect if phy_node
>> present' made the call to phy_scan optional, if the DT has a link to
>> the phy node.
>>
>> However phy_scan has the side effect of calling phy_addr_set, which
>> writes the phy MDIO address to the ethernet controller. If phy_addr_set
>> is not called, and the bootloader has not set the correct address then
>> the driver will fail to function.
>
> Thanks *a lot* for fixing this one! I had the issue on my ReadyNAS 102
> (Armada 370 based) which I had put on a todo list and temporarily

Erm, just to make sure: Armada 370 isn't using mv643xx_eth but mvneta,
are you sure it is (was) related to Jason's fix?

Sebastian

> workarounded by including a 'ping whatever' call in my u-boot env in
> order to force it to do the init. Without it, I was unable to properly
> use the interface. With your fix, after multiple reboots to test it,
> everything works as expected. So, FWIW:
>
> Tested-by: Arnaud Ebalard <arno@natisbad.org>



\
 
 \ /
  Last update: 2013-11-05 23:41    [W:0.045 / U:14.680 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site