Messages in this thread |  | | Subject | Re: [PATCH] Generic WorkQueue Engine (GenWQE) device driver (v4) | From | Frank Haverkamp <> | Date | Mon, 04 Nov 2013 17:30:34 +0100 |
| |
Hi Greg,
Am Mittwoch, den 30.10.2013, 10:37 -0700 schrieb Greg KH: > On Wed, Oct 30, 2013 at 10:32:58AM +0100, Frank Haverkamp wrote: > > +/* > > + * We like to be able to disable the health checking entirely in some > > + * cases e.g. if a card is broken and needs to be analyzed. I > > + * considered using debugfs/sysfs attributes, but I did not see a way > > + * to prevent the thread from being started at driver load time other > > + * than starting it later manually, what I did not like either > > + * in this case (e.g. like the new SRIOV enablement). > > + */ > > +static int genwqe_health_check_interval = 4; /* <= 0: disabled */ > > +module_param(genwqe_health_check_interval, int, 0644); /* read/writeable */ > > +MODULE_PARM_DESC(genwqe_health_check_interval, > > + "check card health every N seconds (0 = disabled)"); > > Module paramaters are driver wide, not device specific. > > If a card is broken, it's broken, send it back. No one will ever know > to set this value, and then you just affected all other cards in the > system for this same driver. > > Just delete this please. > > thanks, > > greg k-h >
Finally I removed all my module parameters or replaced them by debugfs or sysfs attributes.
Regards
Frank
|  |