lkml.org 
[lkml]   [2013]   [Nov]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2] memory: ti-aemif: add bindings for AEMIF driver
On 11/22/2013 11:04 PM, Kumar Gala wrote:
>
> On Nov 20, 2013, at 9:46 AM, Ivan Khoronzhuk <ivan.khoronzhuk@ti.com> wrote:
>
>> Add bindings for AEMIF controller drivers/memory/ti-aemif.c
>>
>
> Binding shouldn’t normally refer to code.
>
> Just saying something like:
>
> Adding binging for TI Async External Memory Interface (AEMIF) controller.
>
>
>> Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk@ti.com>
>> ---
>> .../bindings/memory-controllers/ti-aemif.txt | 198 ++++++++++++++++++++
>> 1 file changed, 198 insertions(+)
>> create mode 100644 Documentation/devicetree/bindings/memory-controllers/ti-aemif.txt
>>
>> diff --git a/Documentation/devicetree/bindings/memory-controllers/ti-aemif.txt b/Documentation/devicetree/bindings/memory-controllers/ti-aemif.txt
>> new file mode 100644
>> index 0000000..be0c0cb
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/memory-controllers/ti-aemif.txt
>> @@ -0,0 +1,198 @@
>> +* Device tree bindings for Texas instruments AEMIF controller
>> +
>> +Th Async External Memory Interface (EMIF16/AEMIF) controller is intended to
>
> The?
>
>> +provide a glue-less interface to a variety of asynchronous memory devices like
>> +ASRA M, NOR and NAND memory. A total of 256M bytes of any of these memories
>> +can be accessed at any given time via four chip selects with 64M byte access
>> +per chip select. Synchronous memories such as DDR1 SD RAM, SDR SDRAM
>> +and Mobile SDR are not supported.
>> +
>> +Documentation:
>> +Davinci DM646x - http://www.ti.com/lit/ug/sprueq7c/sprueq7c.pdf
>> +OMAP-L138 - http://www.ti.com/lit/ug/spruh77a/spruh77a.pdf
>> +Kestone - http://www.ti.com/lit/ug/sprugz3a/sprugz3a.pdf
>> +
>> +Required properties:
>> +
>> +- compatible: "ti,davinci-aemif"
>> + "ti,keystone-aemif"
>> + "ti,omap-L138-aemif"
>> +
>> +- #address-cells: Must be 2. The first cell is the memory partition
>> + number. The 0 partition is for chip selects. And the
>> + second cell is the offset into the partition, for the 0
>> + partition it corresponds to chip select offset.
>> +
>
> Is the first cell just the chip select number?

No. It's rather memory range/partition number. Now there are 2 partitions:
- control partition which is common for all CS interfaces
- CS-specific partition/range
(this one can be splitted according to specific SoC requirement)

As per Keystone TCI6638K2K
Datasheet http://www.ti.com/lit/ds/sprs836d/sprs836d.pdf:

1) the memory range 0 will be from 0x30000000 size 0x10000000:
00 3000 0000 - 00 33FF FFFF 64M EMIF16 CE0
00 3400 0000 - 00 37FF FFFF 64M EMIF16 CE1
00 3800 0000 - 00 3BFF FFFF 64M EMIF16 CE2
00 3C00 0000 - 00 3FFF FFFF 64M EMIF16 CE3

2) the memory range 1:
00 2100 0A00 - 00 2100 0AFF 256 AEMIF Config

And AEMIF node contains definition:
ranges = <0 0 0x30000000 0x10000000
1 0 0x21000A00 0x0000100>;


Child node has (nand):
reg = <0 0 0x4000000 (cs0)
- or - 0 0x4000000 0x4000000 (cs1)
- or - 0 0x8000000 0x4000000 (cs2)
- or - 0 0xC000000 0x4000000 (cs3)
- and -
1 0 0x0000100>; (for all cs)

For example for cs2 child node the resulting mem range 0 will be calculated as

from: 0x30000000 + (0 0x8000000 - 0 0)
size: 0x4000000

We don't encode CS number in reg/ranges, because it will allow simply change
AEMIF DT definitions depending on each SoC
(AEMIF CS memory range can be continuous as above or not, if not - additional
range/partition can be added and child device can select the proper one).

>
> I’m wondering if this is similar to FSL Localbus controller, see the binding:
>
> bindings/powerpc/fsl/lbc.txt

Don't think so :) it looks similar just because of using standard bindings
(gpmc-nand.c mvebu-devbus.txt ti-gpmc.txt and etc.)

>
>> +- #size-cells: Must be set to 1.
>> +
>> +- reg: contains offset/length value for AEMIF control registers
>> + space.
>> +
>> +- ranges: Must be set up to reflect the memory layout for 4
>> + chipselects and for AEMIF control range.
>> +
>> +- clocks: phandle reference to the controller clock. Required only
>> + if clock tree data present in device tree.
>> + See clock-bindings.txt
[..]
>> More majordomo info at http://vger.kernel.org/majordomo-info.html
>

Regards,
-grygorii
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2013-11-26 18:01    [W:0.200 / U:2.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site