lkml.org 
[lkml]   [2013]   [Nov]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH] pinctrl: samsung: Allow pin value to be initialized using pinfunc.
Date
On Tuesday 19 of November 2013 10:59:39 Doug Anderson wrote:
> On Tue, Nov 19, 2013 at 10:46 AM, Stephen Warren <swarren@wwwdotorg.org> wrote:
> > On 11/19/2013 10:15 AM, Tomasz Figa wrote:
> >> This patch extends the range of settings configurable via pinfunc API
> >> to cover pin value as well. This allows configuration of default values
> >> of pins.
> >
> > Shouldn't there be a driver that acquires the GPIO that's output to the
> > pin, and configures the output value? IIRC there have been previous
> > discussions re: having a list of e.g. initial GPIO output values in DT,
> > and that was rejected, and this patch seems to be doing almost the exact
> > same thing, just at the pinctrl level rather than GPIO level.
> >
> > That all said, I admit this could be a useful feature...
>
> I haven't followed all of the previous discussions, but I know I've
> run into scenarios where something like this would be useful. The one
> that comes to mind is:
>
> * We've got GPIOs that default at bootup to a pulled up input since
> the default state of the pin should be "high".
>
> * These pins are really intended to be outputs, like an "enable",
> "reset", or "power down" line for a peripheral. The pullup is strong
> enough to give us a good default state but we really want outputs.
>
> * We'd like to provide this GPIO to a peripheral through device tree.
> ...and we'd like all the pinmux to be setup automatically so we use
> pinctrl-names = "default".
>
> * If we set the pinmux up as "output" then there's a chance that the
> line will glitch at bootup since the pinmux happens (changing the pin
> to output) before the driver has a chance to run.
>
>
> Does that sound like the same scenario you're trying to solve Tomasz?

Yes. That's one of the use cases I had in my mind.

Best regards,
Tomasz



\
 
 \ /
  Last update: 2013-11-20 17:01    [W:0.722 / U:1.016 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site