lkml.org 
[lkml]   [2013]   [Nov]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v4 00/15] usb: phy: msm: Fixes, cleanups and DT support
Date
From: "Ivan T. Ivanov" <iivanov@mm-sol.com>

Hi,

Patches have been tested on top of Stephen's clock controller
patches[1] and recent fixes for chipidea msm glue layer driver
posted here[2]. Hardware platform AP8074 DragonBoard. Only gadget
mode utilized for now.

CV Test Suite engine "Chapter 9 tests" are passing except
"Halt Endpoint Test".

usbtest driver report following failure:
test 13 --> 32 (Broken pipe) ep 81 couldn't set halt, -32

This will be investigated further.
Patches could be applied cleanly on top of the usb-3.13-rc1.

Regards,
Ivan

[1] http://comments.gmane.org/gmane.linux.ports.arm.msm/5375
[2] https://lkml.org/lkml/2013/11/11/310

v4
--
* Squashed checkpatch.pl warning fixes patches
* Squashed dr_mode refactoring with default mode removal
* Dropped patch 10 - usb: phy: msm: Switch clock consumer strings
* Fixed comments from review.
* Utilize reset-framework for LINK and PHY resets if DT is used.
* Added support from second PHY device control.
* Ported reset procedure from codeaurora tree for new chipsets

v3
--
* In patch 1 - functions for reseting PHY and LINK controller just
call platform code if available.
* New stuff is: cleaning up unneeded/unused driver state variables
* Simplified regulator names. There is no references to these names
in tree, so there should not be a problem with this.
* Replace the USB specific clock names with the more standard 'core'
and 'iface' ... names.
* Added devicetree support

v2
--
* Fix compilation issue in patch 1
* Separate regulator changes
* Merge devm_ related changes to one commit
* Drop Lindent patch

v1
--
Following patches make initial cleanup of usb phy found in the Qualcomm
chipsets. Changes include:
* Build time error fix.
* Move driver to Managed Device Resource allocation.
* Checkpatch warnings and error fixes
* Removed usage of global regulators variables.

Ivan T. Ivanov (15):
usb: phy: msm: Move mach dependent code to platform data
usb: phy: msm: Move global regulators variables to driver state
usb: phy: msm: Migrate to Managed Device Resource allocation
usb: phy: msm: Remove unnecessarily check for valid regulators.
usb: phy: msm: Fix checkpatch.pl warnings
usb: phy: msm: Replace custom enum usb_mode_type with enum
usb_dr_mode
usb: phy: msm: Remove unused pclk_src_name
usb: phy: msm: Remove HSUSB prefix from regulator names
usb: phy: msm: Properly check result from platform_get_irq()
usb: phy: msm: Add device tree support and binding information
usb: phy: msm: Use reset framework for LINK and PHY resets
usb: phy: msm: Add support for secondary PHY control
usb: phy: msm: Correct USB PHY Reset sequence for newer platform
usb: phy: msm: Handle disconnect events
usb: phy: msm: Vote for corner of VDD CX instead of voltage of VDD CX

.../devicetree/bindings/usb/msm-hsusb.txt | 78 ++-
arch/arm/mach-msm/board-msm7x30.c | 37 +-
arch/arm/mach-msm/board-qsd8x50.c | 37 +-
drivers/usb/phy/phy-msm-usb.c | 664 +++++++++++---------
include/linux/usb/msm_hsusb.h | 36 +-
include/linux/usb/msm_hsusb_hw.h | 6 +
6 files changed, 529 insertions(+), 329 deletions(-)

--
1.7.9.5



\
 
 \ /
  Last update: 2013-11-12 16:21    [W:0.411 / U:0.828 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site