Messages in this thread | | | Date | Tue, 29 Oct 2013 21:01:51 +0100 | From | Robert Richter <> | Subject | Re: [PATCH 0/5] edac, highbank: Add Calxeda ECX-2000 support |
| |
On 28.10.13 17:06:07, Rob Herring wrote: > On Wed, Oct 16, 2013 at 5:59 AM, Robert Richter <rric@kernel.org> wrote: > > This patch series enables ECC edac support for Calxeda ECX-2000 > > (Midway). The ECX-2000 memory controller is similar to Highbank but > > has different register bases for error and interrupt registers. > > > > Testing the driver uncovered a bug in the interrupt initialization. > > So there is also a fix for this for all the Highbank edac drivers. The > > interrupt was enabled too early which caused a crash if there are > > interrupts pending (ECC errors) during driver initialization. > > > > Also some improvements and unification of edac log messages I found > > useful. > > > > -Robert > > > > > > Rob Herring (1): > > ARM: dts: calxeda: move memory-controller node out of ecx-common.dtsi > > > > Robert Richter (4): > > edac, highbank: Fix interrupt setup of mem and l2 controller > > edac, highbank: Add Calxeda ECX-2000 support > > edac, highbank: Improve and unify naming > > edac: Unify reporting of device info for device, mc and pci > > For the series: > > Acked-by: Rob Herring <rob.herring@calxeda.com>
Thanks Rob and Boris, I applied the patches here:
git://git.kernel.org/pub/scm/linux/kernel/git/rric/oprofile.git edac
and will take care of them and send a pull request directly to Linus.
-Robert
| |