lkml.org 
[lkml]   [2013]   [Jan]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[tip:x86/mm2] x86, 64bit, mm: Make pgd next calculation consistent with pud/pmd
Commit-ID:  c2bdee594ebcf4a531afe795baf18da509438392
Gitweb: http://git.kernel.org/tip/c2bdee594ebcf4a531afe795baf18da509438392
Author: Yinghai Lu <yinghai@kernel.org>
AuthorDate: Thu, 24 Jan 2013 12:19:46 -0800
Committer: H. Peter Anvin <hpa@linux.intel.com>
CommitDate: Tue, 29 Jan 2013 15:12:24 -0800

x86, 64bit, mm: Make pgd next calculation consistent with pud/pmd

Just like the way we calculate next for pud and pmd, aka round down and
add size.

Also, do not do boundary-checking with 'next', and just pass 'end' down
to phys_pud_init() instead. Because the loop in phys_pud_init() stops at
PTRS_PER_PUD and thus can handle a possibly bigger 'end' properly.

Signed-off-by: Yinghai Lu <yinghai@kernel.org>
Link: http://lkml.kernel.org/r/1359058816-7615-6-git-send-email-yinghai@kernel.org
Signed-off-by: H. Peter Anvin <hpa@linux.intel.com>
---
arch/x86/mm/init_64.c | 6 ++----
1 file changed, 2 insertions(+), 4 deletions(-)

diff --git a/arch/x86/mm/init_64.c b/arch/x86/mm/init_64.c
index 191ab12..d7af907 100644
--- a/arch/x86/mm/init_64.c
+++ b/arch/x86/mm/init_64.c
@@ -530,9 +530,7 @@ kernel_physical_mapping_init(unsigned long start,
pgd_t *pgd = pgd_offset_k(start);
pud_t *pud;

- next = (start + PGDIR_SIZE) & PGDIR_MASK;
- if (next > end)
- next = end;
+ next = (start & PGDIR_MASK) + PGDIR_SIZE;

if (pgd_val(*pgd)) {
pud = (pud_t *)pgd_page_vaddr(*pgd);
@@ -542,7 +540,7 @@ kernel_physical_mapping_init(unsigned long start,
}

pud = alloc_low_page();
- last_map_addr = phys_pud_init(pud, __pa(start), __pa(next),
+ last_map_addr = phys_pud_init(pud, __pa(start), __pa(end),
page_size_mask);

spin_lock(&init_mm.page_table_lock);

\
 
 \ /
  Last update: 2013-01-30 02:41    [W:0.423 / U:0.804 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site