lkml.org 
[lkml]   [2013]   [Jan]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3 1/4] drivers: usb: phy: add a new driver for usb part of control module
On Thu, Jan 24, 2013 at 09:32:46PM -0800, Stephen Warren wrote:
> On 01/24/2013 06:19 PM, Kishon Vijay Abraham I wrote:
> > Added a new driver for the usb part of control module. This has an API
> > to power on the USB2 phy and an API to write to the mailbox depending on
> > whether MUSB has to act in host mode or in device mode.
> >
> > Writing to control module registers for doing the above task which was
> > previously done in omap glue and in omap-usb2 phy will be removed.
>
> > diff --git a/Documentation/devicetree/bindings/usb/usb-phy.txt b/Documentation/devicetree/bindings/usb/usb-phy.txt
>
> This file seems to be specific to the TI USB PHYs, not all USB PHYs;
> shouldn't it be renamed ti-usb-phy.txt, or even better renamed to match
> the compatible value it documents, giving ti,omap-usb2.txt?

could be, but that can be done as a separate patch. It's not part of
$SUBJECT.

> > add the address of control module dev conf register until a driver for
> > control module is added
> >
> > +Optional properties:
> > + - ctrl_module : phandle of the control module used by PHY driver to power on
> > + the PHY.
>
> DT property names generally use - not _ as the word separator.

fair enough, Kishon, can you fix this up ?

--
balbi
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2013-01-25 09:42    [W:0.057 / U:0.936 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site