lkml.org 
[lkml]   [2013]   [Jan]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v9 14/20] mfd: omap-usb-host: override number of ports from platform data
Date
Both OMAP4 and 5 exhibit the same revision ID in the REVISION register
but they have different number of ports i.e. 2 and 3 respectively.
So we can't rely on REVISION register for number of ports on OMAP5
and depend on platform data (or device tree) instead.

Signed-off-by: Roger Quadros <rogerq@ti.com>
Reviewed-by: Felipe Balbi <balbi@ti.com>
---
drivers/mfd/omap-usb-host.c | 34 +++++++++++++++++++------------
include/linux/platform_data/usb-omap.h | 1 +
2 files changed, 22 insertions(+), 13 deletions(-)

diff --git a/drivers/mfd/omap-usb-host.c b/drivers/mfd/omap-usb-host.c
index 26319ca..779588b 100644
--- a/drivers/mfd/omap-usb-host.c
+++ b/drivers/mfd/omap-usb-host.c
@@ -493,19 +493,27 @@ static int usbhs_omap_probe(struct platform_device *pdev)
*/
pm_runtime_put_sync(dev);

- switch (omap->usbhs_rev) {
- case OMAP_USBHS_REV1:
- omap->nports = 3;
- break;
- case OMAP_USBHS_REV2:
- omap->nports = 2;
- break;
- default:
- omap->nports = OMAP3_HS_USB_PORTS;
- dev_dbg(dev,
- "USB HOST Rev : 0x%d not recognized, assuming %d ports\n",
- omap->usbhs_rev, omap->nports);
- break;
+ /*
+ * If platform data contains nports then use that
+ * else make out number of ports from USBHS revision
+ */
+ if (pdata->nports) {
+ omap->nports = pdata->nports;
+ } else {
+ switch (omap->usbhs_rev) {
+ case OMAP_USBHS_REV1:
+ omap->nports = 3;
+ break;
+ case OMAP_USBHS_REV2:
+ omap->nports = 2;
+ break;
+ default:
+ omap->nports = OMAP3_HS_USB_PORTS;
+ dev_dbg(dev,
+ "USB HOST Rev:0x%d not recognized, assuming %d ports\n",
+ omap->usbhs_rev, omap->nports);
+ break;
+ }
}

for (i = 0; i < omap->nports; i++)
diff --git a/include/linux/platform_data/usb-omap.h b/include/linux/platform_data/usb-omap.h
index 04c7537..925a4a7 100644
--- a/include/linux/platform_data/usb-omap.h
+++ b/include/linux/platform_data/usb-omap.h
@@ -39,6 +39,7 @@ enum usbhs_omap_port_mode {
};

struct usbhs_omap_platform_data {
+ int nports;
enum usbhs_omap_port_mode port_mode[OMAP3_HS_USB_PORTS];
int reset_gpio_port[OMAP3_HS_USB_PORTS];
struct regulator *regulator[OMAP3_HS_USB_PORTS];
--
1.7.4.1


\
 
 \ /
  Last update: 2013-01-23 12:22    [W:0.201 / U:1.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site