lkml.org 
[lkml]   [2013]   [Jan]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 59/76] ARC: [plat-arfpga] BVCI Latency Unit setup
Date
Signed-off-by: Vineet Gupta <vgupta@synopsys.com>
---
arch/arc/plat-arcfpga/Kconfig | 32 +++++++++++++++++++++
arch/arc/plat-arcfpga/platform.c | 56 ++++++++++++++++++++++++++++++++++++++
2 files changed, 88 insertions(+), 0 deletions(-)

diff --git a/arch/arc/plat-arcfpga/Kconfig b/arch/arc/plat-arcfpga/Kconfig
index 8a1334c..86b7377 100644
--- a/arch/arc/plat-arcfpga/Kconfig
+++ b/arch/arc/plat-arcfpga/Kconfig
@@ -43,4 +43,36 @@ config ARC_SERIAL_BAUD
help
Baud rate for the ARC UART

+menuconfig ARC_HAS_BVCI_LAT_UNIT
+ bool "BVCI Bus Latency Unit"
+ depends on ARC_BOARD_ML509 || ARC_BOARD_ANGEL4
+ help
+ IP to add artifical latency to BVCI Bus Based FPGA builds.
+ The default latency (even worst case) for FPGA is non-realistic
+ (~10 SDRAM, ~5 SSRAM).
+
+config BVCI_LAT_UNITS
+ hex "Latency Unit(s) Bitmap"
+ default "0x0"
+ depends on ARC_HAS_BVCI_LAT_UNIT
+ help
+ There are multiple Latency Units corresponding to the many
+ interfaces of the system bus arbiter (both CPU side as well as
+ the peripheral side).
+ To add latency to ALL memory transaction, choose Unit 0, otherwise
+ for finer grainer - interface wise latency, specify a bitmap (1 bit
+ per unit) of all units. e.g. 1,2,12 will be 0x1003
+
+ Unit 0 - System Arb and Mem Controller
+ Unit 1 - I$ and System Bus
+ Unit 2 - D$ and System Bus
+ ..
+ Unit 12 - IDE Disk controller and System Bus
+
+config BVCI_LAT_CYCLES
+ int "Latency Value in cycles"
+ range 0 63
+ default "30"
+ depends on ARC_HAS_BVCI_LAT_UNIT
+
endif
diff --git a/arch/arc/plat-arcfpga/platform.c b/arch/arc/plat-arcfpga/platform.c
index d98028c..c07636e 100644
--- a/arch/arc/plat-arcfpga/platform.c
+++ b/arch/arc/plat-arcfpga/platform.c
@@ -12,6 +12,7 @@
#include <linux/init.h>
#include <linux/device.h>
#include <linux/platform_device.h>
+#include <linux/io.h>
#include <linux/console.h>
#include <linux/of_platform.h>
#include <asm/setup.h>
@@ -19,6 +20,59 @@
#include <asm/clk.h>
#include <plat/memmap.h>

+/*-----------------------BVCI Latency Unit -----------------------------*/
+
+#ifdef CONFIG_ARC_HAS_BVCI_LAT_UNIT
+
+int lat_cycles = CONFIG_BVCI_LAT_CYCLES;
+
+/* BVCI Bus Profiler: Latency Unit */
+static void __init setup_bvci_lat_unit(void)
+{
+#define MAX_BVCI_UNITS 12
+
+ unsigned int i;
+ unsigned int *base = (unsigned int *)BVCI_LAT_UNIT_BASE;
+ const unsigned long units_req = CONFIG_BVCI_LAT_UNITS;
+ const unsigned int REG_UNIT = 21;
+ const unsigned int REG_VAL = 22;
+
+ /*
+ * There are multiple Latency Units corresponding to the many
+ * interfaces of the system bus arbiter (both CPU side as well as
+ * the peripheral side).
+ *
+ * Unit 0 - System Arb and Mem Controller - adds latency to all
+ * memory trasactions
+ * Unit 1 - I$ and System Bus
+ * Unit 2 - D$ and System Bus
+ * ..
+ * Unit 12 - IDE Disk controller and System Bus
+ *
+ * The programmers model requires writing to lat_unit reg first
+ * and then the latency value (cycles) to lat_value reg
+ */
+
+ if (CONFIG_BVCI_LAT_UNITS == 0) {
+ writel(0, base + REG_UNIT);
+ writel(lat_cycles, base + REG_VAL);
+ pr_info("BVCI Latency for all Memory Transactions %d cycles\n",
+ lat_cycles);
+ } else {
+ for_each_set_bit(i, &units_req, MAX_BVCI_UNITS) {
+ writel(i + 1, base + REG_UNIT); /* loop is 0 based */
+ writel(lat_cycles, base + REG_VAL);
+ pr_info("BVCI Latency for Unit[%d] = %d cycles\n",
+ (i + 1), lat_cycles);
+ }
+ }
+}
+#else
+static void __init setup_bvci_lat_unit(void)
+{
+}
+#endif
+
/*----------------------- Platform Devices -----------------------------*/

#if defined(CONFIG_SERIAL_ARC) || defined(CONFIG_SERIAL_ARC_MODULE)
@@ -115,6 +169,8 @@ void __init arc_platform_early_init(void)
{
pr_info("[plat-arcfpga]: registering early dev resources\n");

+ setup_bvci_lat_unit();
+
arc_fpga_serial_init();
}

--
1.7.4.1


\
 
 \ /
  Last update: 2013-01-18 14:21    [W:0.851 / U:0.028 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site