lkml.org 
[lkml]   [2013]   [Jan]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] ARM: OMAP: gpmc: Add device tree documentation for elm handle
Date
In case ELM module available, omap2 NAND driver can opt for hardware
correction method for bit flip errors in NAND flash with BCH. Hence the
detection of ELM module is done through devicetree population of elm_id.
This patch update device tree documentation for gpmc-nand for elm-id
data population.

Signed-off-by: Philip Avinash <avinashphilip@ti.com>
---
This patch based [1] and depends on [2]. As Artem suggested, this patch can
go in omap_tree due to the dependency on [3].
Discussion can found at [4]

Tony,
Can you accept this patch.

1. http://git.kernel.org/?p=linux/kernel/git/tmlind/linux-omap.git;a=shortlog;h=refs/heads/omap-for-v3.9/gpmc
2. mtd: nand: omap2: Support for hardware BCH error correction
http://git.infradead.org/users/dedekind/l2-mtd-2.6.git/commit/576daed18c3f27bb5d0e57e1df11e8f7b493dce8
3. ARM: OMAP: gpmc: add DT bindings for GPMC timings and NAND
http://git.kernel.org/?p=linux/kernel/git/tmlind/linux-omap.git;a=commit;h=bc6b1e7b86f5d8e4a6fc1c0189e64bba4077efe0
4. https://lkml.org/lkml/2013/1/17/167

.../devicetree/bindings/mtd/gpmc-nand.txt | 4 ++++
1 file changed, 4 insertions(+)

diff --git a/Documentation/devicetree/bindings/mtd/gpmc-nand.txt b/Documentation/devicetree/bindings/mtd/gpmc-nand.txt
index 9f464f9..e7f8d7e 100644
--- a/Documentation/devicetree/bindings/mtd/gpmc-nand.txt
+++ b/Documentation/devicetree/bindings/mtd/gpmc-nand.txt
@@ -29,6 +29,9 @@ Optional properties:
"bch4" 4-bit BCH ecc code
"bch8" 8-bit BCH ecc code

+ - elm_id: Specifies elm device node. This is required to support BCH
+ error correction using ELM module.
+
For inline partiton table parsing (optional):

- #address-cells: should be set to 1
@@ -46,6 +49,7 @@ Example for an AM33xx board:
#address-cells = <2>;
#size-cells = <1>;
ranges = <0 0 0x08000000 0x2000>; /* CS0: NAND */
+ elm_id = <&elm>;

nand@0,0 {
reg = <0 0 0>; /* CS0, offset 0 */
--
1.7.9.5


\
 
 \ /
  Last update: 2013-01-18 06:41    [W:0.052 / U:2.636 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site