lkml.org 
[lkml]   [2012]   [Sep]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH] mmc: omap_hsmmc: Enable HSPE bit for high speed cards
On Tue, Sep 4, 2012 at 6:39 PM, Hebbar, Gururaja <gururaja.hebbar@ti.com> wrote:
> HSMMC IP on AM33xx need a special setting to handle High-speed cards.
> Other platforms like TI81xx, OMAP4 may need this as-well. This depends
> on the HSMMC IP timing closure done for the high speed cards.
>
> From AM335x TRM (SPRUH73F - 18.3.12 Output Signals Generation)
>
> The MMC/SD/SDIO output signals can be driven on either falling edge or
> rising edge depending on the SD_HCTL[2] HSPE bit. This feature allows
> to reach better timing performance, and thus to increase data transfer
> frequency.
>
> There are few pre-requisites for enabling the HSPE bit
> - Controller should support High-Speed-Enable Bit and
> - Controller should not be using DDR Mode and
> - Controller should advertise that it supports High Speed in
> capabilities register and
> - MMC/SD clock coming out of controller > 25MHz
>

The patch is well written. But then, I don't see a need for a DT
binding for this feature.
By definition, HS implies 25MHz or above, so that check seems to be
redundant as well.
Meanwhile, I'll check with HSPE enabled on OMAP.

Regards,
Venkat.


\
 
 \ /
  Last update: 2012-09-12 11:21    [W:0.108 / U:2.524 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site