Messages in this thread | | | Date | Fri, 31 Aug 2012 11:32:41 +0200 | From | Benoit Cousson <> | Subject | Re: [PATCHv3 0/4] Add device tree data for omap5 |
| |
Hi Sourav,
While rebasing your series on top of Tony's lo/devel-dt, I realized that the keypad nodes are not located at the correct place :-(
At the moment they are just floating at the top level of the dts while they belong to the ocp bus and thus should be put there.
I fixed that since it was trivial and cleaned as well the changelog and the comments to aligned then properly. I added as well the physical address to the node name and a label for easy reference at board level.
I did some basic test on my OMAP4 sdp, but that all I can do so far.
Could you just check if this is still fine for OMAP5 before I ask Tony to pull that.
I based that on top of Tony's DT patches due to conflict with the existing MMC patch in it.
The following changes since commit 85d7ff9b907685b6469058888f1d961b3e8d47ad: Olof Johansson (1): ARM: omap: add dtb targets
are available in the git repository at:
git://git.kernel.org/pub/scm/linux/kernel/git/bcousson/linux-omap-dt.git for_3.7/dts
Sourav Poddar (6): arm/dts: omap5-evm: Add I2C support arm/dts: omap5-evm: Add tmp102 sensor support arm/dts: omap5-evm: Add keypad data arm/dts: omap5-evm: Add bmp085 sensor support arm/dts: omap4-sdp: Add keypad data Documentation: dt: i2c: trivial-devices: Update for tmp102
.../devicetree/bindings/i2c/trivial-devices.txt | 1 + arch/arm/boot/dts/omap4-sdp.dts | 70 ++++++++++++++++++++ arch/arm/boot/dts/omap4.dtsi | 5 ++ arch/arm/boot/dts/omap5-evm.dts | 33 +++++++++ arch/arm/boot/dts/omap5.dtsi | 40 +++++++++++ 5 files changed, 149 insertions(+), 0 deletions(-)
Regards, Benoit
| |