Messages in this thread | | | Date | Fri, 24 Aug 2012 14:19:40 -0400 | From | jbaron <> | Subject | Re: About multiple queries to control using $DBGMT/dynamic_debug/control |
| |
On Wed, Aug 22, 2012 at 07:42:14PM +0800, Jianpeng Ma wrote: > Hi, > I used the $DBGMT/dynamic_debug/control to control printing debuginfo.But When i wote multiple queries which has at least one didn't match, > the result is ok which no error can return. > So i think i wrote correct queries.But until using dmesg, i only found error. > And if parm verbose of dynamic_debug is zero, i can't find the result by dmesg. > So i think it's not convenient. > If it did not found any query,it should return error. > > Thanks!
Hi,
You can verify what changes have occured by looking in the $DBGMT/dynamic_debug/control file, and verifying what statements have been matched. For example, we add a 'p' when printing is enabled. Does that address your concern?
As these debug statements come and go, I think I'd prefer not to error out in this case.
Thanks,
-Jason
| |