Messages in this thread Patch in this message | | | From | manoj.iyer@canonica ... | Subject | [PATCH 1/1] xhci: Recognize USB 3.0 devices as superspeed at powerup | Date | Wed, 22 Aug 2012 11:53:18 -0500 |
| |
From: Manoj Iyer <manoj.iyer@canonical.com>
On Intel Panther Point chipset USB 3.0 devices show up as high-speed devices on powerup, but after an s3 cycle they are correctly recognized as SuperSpeed. At powerup switch the port to xHCI so that USB 3.0 devices are correctly recognized.
BugLink: http://bugs.launchpad.net/bugs/1000424
Signed-off-by: Manoj Iyer <manoj.iyer@canonical.com> --- drivers/usb/host/pci-quirks.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/usb/host/pci-quirks.c b/drivers/usb/host/pci-quirks.c index c5e9e4a..486e812 100644 --- a/drivers/usb/host/pci-quirks.c +++ b/drivers/usb/host/pci-quirks.c @@ -870,9 +870,10 @@ static void __devinit quirk_usb_handoff_xhci(struct pci_dev *pdev) /* Disable any BIOS SMIs and clear all SMI events*/ writel(val, base + ext_cap_offset + XHCI_LEGACY_CONTROL_OFFSET); +hc_init: if (usb_is_intel_switchable_xhci(pdev)) usb_enable_xhci_ports(pdev); -hc_init: + op_reg_base = base + XHCI_HC_LENGTH(readl(base)); /* Wait for the host controller to be ready before writing any -- 1.7.9.5
| |