Messages in this thread | | | Date | Mon, 18 Jun 2012 21:38:13 +0200 | From | Marc Kleine-Budde <> | Subject | Re: [PATCH] c_can_pci: generic module for C_CAN/D_CAN on PCI |
| |
On 06/14/2012 01:43 PM, Federico Vaga wrote: > Signed-off-by: Federico Vaga <federico.vaga@gmail.com> > Acked-by: Giancarlo Asnaghi <giancarlo.asnaghi@st.com> > Cc: Alan Cox <alan@linux.intel.com> > --- > drivers/net/can/c_can/Kconfig | 7 ++ > drivers/net/can/c_can/Makefile | 1 + > drivers/net/can/c_can/c_can_pci.c | 236 +++++++++++++++++++++++++++++++++++++ > 3 files changed, 244 insertions(+) > create mode 100644 drivers/net/can/c_can/c_can_pci.c > > diff --git a/drivers/net/can/c_can/Kconfig b/drivers/net/can/c_can/Kconfig > index 25d371c..3b83baf 100644 > --- a/drivers/net/can/c_can/Kconfig > +++ b/drivers/net/can/c_can/Kconfig > @@ -13,4 +13,11 @@ config CAN_C_CAN_PLATFORM > boards from ST Microelectronics (http://www.st.com) like the > SPEAr1310 and SPEAr320 evaluation boards & TI (www.ti.com) > boards like am335x, dm814x, dm813x and dm811x. > + > +config CAN_C_CAN_PCI > + tristate "Generic PCI Bus based C_CAN/D_CAN driver" > + depends on PCI > + ---help--- > + This driver adds support for the C_CAN/D_CAN chips connected > + to the PCI bus. > endif > diff --git a/drivers/net/can/c_can/Makefile b/drivers/net/can/c_can/Makefile > index 9273f6d..ad1cc84 100644 > --- a/drivers/net/can/c_can/Makefile > +++ b/drivers/net/can/c_can/Makefile > @@ -4,5 +4,6 @@ > > obj-$(CONFIG_CAN_C_CAN) += c_can.o > obj-$(CONFIG_CAN_C_CAN_PLATFORM) += c_can_platform.o > +obj-$(CONFIG_CAN_C_CAN_PCI) += c_can_pci.o > > ccflags-$(CONFIG_CAN_DEBUG_DEVICES) := -DDEBUG > diff --git a/drivers/net/can/c_can/c_can_pci.c b/drivers/net/can/c_can/c_can_pci.c > new file mode 100644 > index 0000000..7bdb793 > --- /dev/null > +++ b/drivers/net/can/c_can/c_can_pci.c > @@ -0,0 +1,236 @@ > +/* > + * PCI bus driver for Bosch C_CAN/D_CAN controller > + * > + * Copyright (C) 2012 Federico Vaga <federico.vaga@gmail.com> > + * > + * Borrowed from c_can_platform.c > + * > + * This file is licensed under the terms of the GNU General Public > + * License version 2. This program is licensed "as is" without any > + * warranty of any kind, whether express or implied. > + */ > + > +#include <linux/kernel.h> > +#include <linux/module.h> > +#include <linux/netdevice.h> > +#include <linux/clk.h> > +#include <linux/pci.h> > + > +#include <linux/can/dev.h> > + > +#include "c_can.h" > + > +enum c_can_pci_reg_align { > + C_CAN_REG_ALIGN_16, > + C_CAN_REG_ALIGN_32, > +}; > + > +struct c_can_pci_data { > + /* Specify if is C_CAN or D_CAN */ > + enum c_can_dev_id type; > + /* Set the register alignment in the memory */ > + enum c_can_pci_reg_align reg_align; > + /* Set the frequency if clk is not usable */ > + unsigned int freq; > +}; > + > +/* > + * 16-bit c_can registers can be arranged differently in the memory > + * architecture of different implementations. For example: 16-bit > + * registers can be aligned to a 16-bit boundary or 32-bit boundary etc. > + * Handle the same by providing a common read/write interface. > + */ > +static u16 c_can_pci_read_reg_aligned_to_16bit(struct c_can_priv *priv, > + enum reg index) > +{ > + return readw(priv->base + priv->regs[index]); > +} > + > +static void c_can_pci_write_reg_aligned_to_16bit(struct c_can_priv *priv, > + enum reg index, u16 val) > +{ > + writew(val, priv->base + priv->regs[index]); > +} > + > +static u16 c_can_pci_read_reg_aligned_to_32bit(struct c_can_priv *priv, > + enum reg index) > +{ > + return readw(priv->base + 2 * priv->regs[index]); > +} > + > +static void c_can_pci_write_reg_aligned_to_32bit(struct c_can_priv *priv, > + enum reg index, u16 val) > +{ > + writew(val, priv->base + 2 * priv->regs[index]); > +} > + > +static int __devinit c_can_pci_probe(struct pci_dev *pdev, > + const struct pci_device_id *ent) > +{ > + struct c_can_pci_data *c_can_pci_data = (void *)ent->driver_data; > + struct c_can_priv *priv; > + struct net_device *dev; > + void __iomem *addr; > + struct clk *clk; > + int ret; > + > + ret = pci_enable_device(pdev); > + if (ret) { > + dev_err(&pdev->dev, "pci_enable_device FAILED\n"); > + goto out; > + } > + > + ret = pci_request_regions(pdev, KBUILD_MODNAME); > + if (ret) { > + dev_err(&pdev->dev, "pci_request_regions FAILED\n"); > + goto out_disable_device; > + } > + > + pci_set_master(pdev); > + pci_enable_msi(pdev); > + > + addr = pci_iomap(pdev, 0, pci_resource_len(pdev, 0)); > + if (!addr) { > + dev_err(&pdev->dev, > + "device has no PCI memory resources, " > + "failing adapter\n"); > + ret = -ENOMEM; > + goto out_release_regions; > + } > + > + /* allocate the c_can device */ > + dev = alloc_c_can_dev(); > + if (!dev) { > + ret = -ENOMEM; > + goto out_iounmap; > + } > + > + priv = netdev_priv(dev); > + pci_set_drvdata(pdev, dev); > + SET_NETDEV_DEV(dev, &pdev->dev); > + > + dev->irq = pdev->irq; > + priv->base = addr; > + > + if (!c_can_pci_data->freq) { > + /* get the appropriate clk */ > + clk = clk_get(&pdev->dev, NULL); > + if (IS_ERR(clk)) { > + dev_err(&pdev->dev, "no clock defined\n"); > + ret = -ENODEV; > + goto out_free_c_can; > + } > + priv->can.clock.freq = clk_get_rate(clk); > + priv->priv = clk; > + } else { > + priv->can.clock.freq = c_can_pci_data->freq; > + priv->priv = NULL; > + } > + > + /* Configure CAN type */ > + switch (c_can_pci_data->type) { > + case C_CAN_DEVTYPE: > + priv->regs = reg_map_c_can; > + break; > + case D_CAN_DEVTYPE: > + priv->regs = reg_map_d_can; > + priv->can.ctrlmode_supported |= CAN_CTRLMODE_3_SAMPLES; > + break; > + default: > + ret = -EINVAL; > + goto out_free_clock; > + } > + > + /* Configure access to registers */ > + switch (c_can_pci_data->reg_align) { > + case C_CAN_REG_ALIGN_32: > + priv->read_reg = c_can_pci_read_reg_aligned_to_32bit; > + priv->write_reg = c_can_pci_write_reg_aligned_to_32bit; > + break; > + case C_CAN_REG_ALIGN_16: > + priv->read_reg = c_can_pci_read_reg_aligned_to_16bit; > + priv->write_reg = c_can_pci_write_reg_aligned_to_16bit; > + break; > + default: > + ret = -EINVAL; > + goto out_free_clock; > + } > + > + ret = register_c_can_dev(dev); > + if (ret) { > + dev_err(&pdev->dev, "registering %s failed (err=%d)\n", > + KBUILD_MODNAME, ret); > + goto out_free_clock; > + } > + > + dev_dbg(&pdev->dev, "%s device registered (regs=%p, irq=%d)\n", > + KBUILD_MODNAME, priv->regs, dev->irq); > + > + return 0; > + > +out_free_clock: > + if (priv->priv) > + clk_put(priv->priv); > +out_free_c_can: > + pci_set_drvdata(pdev, NULL); > + free_c_can_dev(dev); > +out_iounmap: > + pci_iounmap(pdev, priv->base);
I get this warning:
socketcan/linux/drivers/net/can/c_can/c_can_pci.c: In function 'c_can_pci_probe': socketcan/linux/drivers/net/can/c_can/c_can_pci.c:71: warning: 'priv' may be used uninitialized in this function
What about:
- pci_iounmap(pdev, priv->base); + pci_iounmap(pdev, addr);
> +out_release_regions: > + pci_disable_msi(pdev); > + pci_clear_master(pdev); > + pci_release_regions(pdev); > +out_disable_device: > + pci_disable_device(pdev); > +out: > + return ret; > +} > + > +static void __devexit c_can_pci_remove(struct pci_dev *pdev) > +{ > + struct net_device *dev = pci_get_drvdata(pdev); > + struct c_can_priv *priv = netdev_priv(dev); > + > + unregister_c_can_dev(dev); > + > + if (priv->priv) > + clk_put(priv->priv); > + > + pci_set_drvdata(pdev, NULL); > + free_c_can_dev(dev); > + > + pci_iounmap(pdev, priv->base); > + pci_disable_msi(pdev); > + pci_clear_master(pdev); > + pci_release_regions(pdev); > + pci_disable_device(pdev); > +} > + > +static struct c_can_pci_data c_can_sta2x11= { > + .type = C_CAN_DEVTYPE, > + .reg_align = C_CAN_REG_ALIGN_32, > + .freq = 52000000, /* 52 Mhz */ > +}; > + > +#define C_CAN_ID(_vend, _dev, _driverdata) { \ > + PCI_DEVICE(_vend, _dev), \ > + .driver_data = (unsigned long)&_driverdata, \ > +} > +static DEFINE_PCI_DEVICE_TABLE(c_can_pci_tbl) = { > + C_CAN_ID(PCI_VENDOR_ID_STMICRO, PCI_DEVICE_ID_STMICRO_CAN, > + c_can_sta2x11), > + {}, > +}; > +static struct pci_driver c_can_pci_driver = { > + .name = KBUILD_MODNAME, > + .id_table = c_can_pci_tbl, > + .probe = c_can_pci_probe, > + .remove = __devexit_p(c_can_pci_remove), > +}; > + > +module_pci_driver(c_can_pci_driver); > + > +MODULE_AUTHOR("Federico Vaga <federico.vaga@gmail.com>"); > +MODULE_LICENSE("GPL v2"); > +MODULE_DESCRIPTION("PCI CAN bus driver for Bosch C_CAN/D_CAN controller"); > +MODULE_DEVICE_TABLE(pci, c_can_pci_tbl);
regards, Marc
-- Pengutronix e.K. | Marc Kleine-Budde | Industrial Linux Solutions | Phone: +49-231-2826-924 | Vertretung West/Dortmund | Fax: +49-5121-206917-5555 | Amtsgericht Hildesheim, HRA 2686 | http://www.pengutronix.de |
[unhandled content-type:application/pgp-signature] | |