Messages in this thread | | | Subject | Re: [PATCH] davinci_emac: Add cpu_freq support | From | Ben Hutchings <> | Date | Mon, 9 Apr 2012 16:56:18 +0100 |
| |
On Mon, 2012-04-09 at 16:19 +0530, Manjunathappa, Prakash wrote: > Reconfigure interrupt coalesce parameter for changed emac bus_freq > due to DVFS. > > Signed-off-by: Manjunathappa, Prakash <prakash.pm@ti.com> > --- > drivers/net/ethernet/ti/davinci_emac.c | 60 ++++++++++++++++++++++++++++++++ > 1 files changed, 60 insertions(+), 0 deletions(-) > > diff --git a/drivers/net/ethernet/ti/davinci_emac.c b/drivers/net/ethernet/ti/davinci_emac.c > index 174a334..11d3bd7 100644 > --- a/drivers/net/ethernet/ti/davinci_emac.c > +++ b/drivers/net/ethernet/ti/davinci_emac.c > @@ -50,6 +50,7 @@ > #include <linux/ctype.h> > #include <linux/spinlock.h> > #include <linux/dma-mapping.h> > +#include <linux/cpufreq.h> > #include <linux/clk.h> > #include <linux/platform_device.h> > #include <linux/semaphore.h> > @@ -344,6 +345,9 @@ struct emac_priv { > /*platform specific members*/ > void (*int_enable) (void); > void (*int_disable) (void); > +#ifdef CONFIG_CPU_FREQ > + struct notifier_block freq_transition; > +#endif > }; > > /* clock frequency for EMAC */ > @@ -1761,6 +1765,46 @@ static const struct net_device_ops emac_netdev_ops = { > #endif > }; > > +#ifdef CONFIG_CPU_FREQ > +static int davinci_emac_cpufreq_transition(struct notifier_block *nb, > + unsigned long val, void *data) > +{ > + int ret = 0; > + struct emac_priv *priv; > + > + priv = container_of(nb, struct emac_priv, freq_transition); > + if (priv->coal_intvl != 0) { > + if (val == CPUFREQ_POSTCHANGE) { > + if (emac_bus_frequency != clk_get_rate(emac_clk)) { > + struct ethtool_coalesce coal; > + > + emac_bus_frequency = clk_get_rate(emac_clk); > + > + priv->bus_freq_mhz = (u32)(emac_bus_frequency / > + 1000000); > + coal.rx_coalesce_usecs = (priv->coal_intvl > + << 4); > + ret = emac_set_coalesce(priv->ndev, &coal); [...]
Ick. Why don't you break up emac_set_coalesce() so that you can push this one value to the hardware without faking up a struct ethtool_coalesce? Don't you need to push it on reset/resume anyway?
Ben.
-- Ben Hutchings, Staff Engineer, Solarflare Not speaking for my employer; that's the marketing department's job. They asked us to note that Solarflare product names are trademarked.
| |