lkml.org 
[lkml]   [2012]   [Apr]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 6/9] plat-nomadik: new sleep mode pincfg macros
Date
From: Linus Walleij <linus.walleij@linaro.org>

This adds a few sleep mode pin config macros for sleep mode
for the Nomadik GPIO/pin controller.

Signed-off-by: Rickard Andersson <rickard.andersson@stericsson.com>
Signed-off-by: Rikard Olsson <rikard.p.olsson@stericsson.com>
Signed-off-by: Jonas Aaberg <jonas.aberg@stericsson.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
---
arch/arm/plat-nomadik/include/plat/pincfg.h | 13 +++++++++++++
1 file changed, 13 insertions(+)

diff --git a/arch/arm/plat-nomadik/include/plat/pincfg.h b/arch/arm/plat-nomadik/include/plat/pincfg.h
index da6b1e3..c015133 100644
--- a/arch/arm/plat-nomadik/include/plat/pincfg.h
+++ b/arch/arm/plat-nomadik/include/plat/pincfg.h
@@ -24,6 +24,7 @@
* bit 16..18 - SLPM pull up/down state
* bit 19..20 - SLPM direction
* bit 21..22 - SLPM Value (if output)
+ * bit 23..25 - PDIS value (if input)
*
* to facilitate the definition, the following macros are provided
*
@@ -67,6 +68,10 @@ typedef unsigned long pin_cfg_t;
/* These two replace the above in DB8500v2+ */
#define PIN_SLPM_WAKEUP_ENABLE (NMK_GPIO_SLPM_WAKEUP_ENABLE << PIN_SLPM_SHIFT)
#define PIN_SLPM_WAKEUP_DISABLE (NMK_GPIO_SLPM_WAKEUP_DISABLE << PIN_SLPM_SHIFT)
+#define PIN_SLPM_USE_MUX_SETTINGS_IN_SLEEP PIN_SLPM_WAKEUP_DISABLE
+
+#define PIN_SLPM_GPIO PIN_SLPM_WAKEUP_ENABLE /* In SLPM, pin is a gpio */
+#define PIN_SLPM_ALTFUNC PIN_SLPM_WAKEUP_DISABLE /* In SLPM, pin is altfunc */

#define PIN_DIR_SHIFT 14
#define PIN_DIR_MASK (0x1 << PIN_DIR_SHIFT)
@@ -105,6 +110,14 @@ typedef unsigned long pin_cfg_t;
#define PIN_SLPM_VAL_LOW ((1 + 0) << PIN_SLPM_VAL_SHIFT)
#define PIN_SLPM_VAL_HIGH ((1 + 1) << PIN_SLPM_VAL_SHIFT)

+#define PIN_SLPM_PDIS_SHIFT 23
+#define PIN_SLPM_PDIS_MASK (0x3 << PIN_SLPM_PDIS_SHIFT)
+#define PIN_SLPM_PDIS(x) \
+ (((x) & PIN_SLPM_PDIS_MASK) >> PIN_SLPM_PDIS_SHIFT)
+#define PIN_SLPM_PDIS_NO_CHANGE (0 << PIN_SLPM_PDIS_SHIFT)
+#define PIN_SLPM_PDIS_DISABLED (1 << PIN_SLPM_PDIS_SHIFT)
+#define PIN_SLPM_PDIS_ENABLED (2 << PIN_SLPM_PDIS_SHIFT)
+
#define PIN_LOWEMI_SHIFT 25
#define PIN_LOWEMI_MASK (0x1 << PIN_LOWEMI_SHIFT)
#define PIN_LOWEMI(x) (((x) & PIN_LOWEMI_MASK) >> PIN_LOWEMI_SHIFT)
--
1.7.9.2


\
 
 \ /
  Last update: 2012-04-23 11:29    [W:0.251 / U:1.388 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site