lkml.org 
[lkml]   [2012]   [Feb]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2 v2] gpio/stmpe: support no-irq mode
Hi Linus,

On Thu, Jan 26, 2012 at 10:17:15PM +0100, Linus Walleij wrote:
> From: Chris Blair <chris.blair@stericsson.com>
>
> Adds support for boards which have an STMPE GPIO device without the
> interrupt pin connected. This means that no interrupt can be received
> but the GPIO pins can still be driven and read.
>
> Cc: Grant Likely <grant.likely@secretlab.ca>
> Acked-by: Viresh Kumar <viresh.kumar@st.com>
> Tested-by: Michel Jaouen <michel.jaouen@stericsson.com>
> Signed-off-by: Chris Blair <chris.blair@stericsson.com>
> ---
> ChangeLog v1->v2:
> - Removes the use of the new no_irq platform data member and
> instead uses the value obtained for the cell irq to know if irqs
> are supported or not. If irqs are not supported, the device
> will not have been given an irq resource and the irq value
> will be invalid.
>
> This depends on the previous patch to the MFD
> code so should better be merged into the MFD tree with the
> previous patch.
Ok, I'm taking this one. It would be nice to get Grant's ACK as well.
Linus, you did not SOB this one. Did you simply forget ?

Cheers,
Samuel.

--
Intel Open Source Technology Centre
http://oss.intel.com/


\
 
 \ /
  Last update: 2012-02-20 18:09    [W:0.036 / U:0.348 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site