lkml.org 
[lkml]   [2012]   [Dec]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: BUG: scheduling while atomic: ifup-bonding/3711/0x00000002 -- V3.6.7
Sorry for the delay.... my distro (Suse) has made rebooting my system
a chore (have to often boot from rescue to get it to come up because
they put mount libs in /usr/lib expecting they will always boot
from their ram disk -- preventing those of use who boot directly
from disk from doing so easily...grrr.

Jay Vosburgh wrote:
> The miimon functionality is used to check link state and notice
> when slaves lose carrier.
---
If I am running 'rr' on 2 channels -- specifically for the purpose
of link speed aggregation (getting 1 20Gb channel out of 2 10Gb channels)
I'm not sure I see how miimon would provide benefit. -- if 1 link dies,
the other, being on the same card is likely to be dead too, so would
it really serve a purpose?


> Running without it will not detect failure of
> the bonding slaves, which is likely not what you want. The mode,
> balance-rr in your case, is what selects the load balance to use, and is
> separate from the miimon.
>
----
Wouldn't the entire link die if a slave dies -- like RAID0, 1 disk
dies, the entire link goes down?

The other end (windows) doesn't dynamically config for a static-link
aggregation, so I don't think it would provide benefit.

> That said, the problem you're seeing appears to be caused by two
> things: bonding holds a lock (in addition to RTNL) when calling
> __ethtool_get_settings, and an ixgbe function in the call path to
> retrieve the settings, ixgbe_acquire_swfw_sync_X540, can sleep.
>
> The test patch above handles one case in bond_enslave, but there
> is another case in bond_miimon_commit when a slave changes link state
> from down to up, which will occur shortly after the slave is added.
>
----
Added your 2nd patch -- no more error messages...

however -- likely unrelated, the max speed read or write I am seeing
is about 500MB/s, and that is rare -- usually it's barely <3x a 1Gb
network speed. (119/125 MB R/W). I'm not at all sure it's really
combining the links
properly. Anyway to verify that?


On the windows side it shows the bond-link as a 20Gb connection, but
I don't see anyplace for something similar on linux.





\
 
 \ /
  Last update: 2012-12-07 23:41    [W:0.043 / U:1.396 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site