lkml.org 
[lkml]   [2012]   [Dec]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH V5 2/2] mfd: stmpe: Update DT support in stmpe driver
From
On 6 December 2012 16:05, Lee Jones <lee.jones@linaro.org> wrote:
>> > Or you could not put unnecessary bindings into the Device Tree
>> > by putting two and two together and realise that using the table
>> > is the correct thing to do instead. This actually gives reason
>> > to you previous patch, but should probably be fixed-up into it
>> > so it has some proper meaning/purpose. ;)
>>
>> Couldn't understand this one :(
>
> Really?

I tried again, but couldn't get it :(

> Let's break it down - what do you need "stmpe,id" for?

To distinguish two instances of of stmpe811 (for instance) on a board.
Names of stmpe sub-modules would contain .0, .1, if we have an id
passed to it. Passing -1 would create same names for both gpio blocks
which belonged to different stmpe811's.


\
 
 \ /
  Last update: 2012-12-06 12:21    [W:0.106 / U:0.084 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site