Messages in this thread | | | Date | Wed, 7 Nov 2012 13:49:36 +0100 | Subject | Re: [PATCH v3] ARM: zynq: Allow UART1 to be used as DEBUG_LL console. | From | Michal Simek <> |
| |
2012/11/5 Josh Cartwright <josh.cartwright@ni.com>: > On Mon, Nov 05, 2012 at 04:45:49PM -0500, Nick Bowler wrote: >> The main UART on the Xilinx ZC702 board is UART1, located at address >> e0001000. Add a Kconfig option to select this device as the low-level >> debugging port. This allows the really early boot printouts to reach >> the USB serial adaptor on this board. >> >> For consistency's sake, add a choice entry for UART0 even though it is >> the the default if UART1 is not selected. >> >> Signed-off-by: Nick Bowler <nbowler@elliptictech.com> >> Tested-by: Josh Cartwright <josh.cartwright@ni.com> >> --- >> Sorry all for the phenominal delay in sending this out. Josh, I kept >> your Tested-By since this version is Obviously Equivalent??? to v2... > > I re-tested again just in case and everything is good.
Thanks guys, Applied.
Michal
| |