Messages in this thread | | | Date | Mon, 5 Nov 2012 15:54:10 -0600 | From | Josh Cartwright <> | Subject | Re: [PATCH v3] ARM: zynq: Allow UART1 to be used as DEBUG_LL console. |
| |
On Mon, Nov 05, 2012 at 04:45:49PM -0500, Nick Bowler wrote: > The main UART on the Xilinx ZC702 board is UART1, located at address > e0001000. Add a Kconfig option to select this device as the low-level > debugging port. This allows the really early boot printouts to reach > the USB serial adaptor on this board. > > For consistency's sake, add a choice entry for UART0 even though it is > the the default if UART1 is not selected. > > Signed-off-by: Nick Bowler <nbowler@elliptictech.com> > Tested-by: Josh Cartwright <josh.cartwright@ni.com> > --- > Sorry all for the phenominal delay in sending this out. Josh, I kept > your Tested-By since this version is Obviously Equivalent??? to v2...
I re-tested again just in case and everything is good.
Thanks, Josh [unhandled content-type:application/pgp-signature] | |