lkml.org 
[lkml]   [2012]   [Nov]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH V2 1/3] mmc: esdhc: enable polling to detect card by itself
On Mon, Nov 05, 2012 at 11:34:49AM +0800, yongd wrote:
> From the code logic, without SDHCI_QUIRK_BROKEN_CARD_DETECTION for ESDHC_CD_GPIO, when your card (using
> GPIO detection) is removed, we can know the card's absence through the fake CARD_PRESENT flag in esdhc_readl_le().
> As a result, we can quickly return ENOMEDIUM error without command sending. Finally mmc_rescan can know the card
> is removed.
>
Yes, that's the existing implementation, which does not require retry
sending MMC_SEND_STATUS to know if card is removed.

> On the other hand, with SDHCI_QUIRK_BROKEN_CARD_DETECTION for ESDHC_CD_GPIO, we will just send MMC_SEND_STATUS
> command (cd_irq->sdhci_tasklet_card->mmc_recan->mmc_sd_detect->mmc_sd_alive), and we will find error since the card
> is already gone. Finally, we shall also know the card is removed.
>
> This is really strange why the removal message shows up together with the next card inserting message.
> Could u pls tell us more about what actually happened when the card is removed with my patches? Did the GPIO interrupt
> happen? Was mmc_rescan() called? Did mmc_sd_detect() finally find error when it sent MMC_SEND_STATUS? What step did
> the card removing procedure arrive at? Really really thanks a lot:-)
>
I just tracked it down a little bit. Interesting enough, it depends on
how I remove the card. If I do it slowly, when the gpio interrupt
triggers the MMC_SEND_STATUS query, the command can still retrieve
the card status successfully. Thus driver does not detect the card
removal. If I remove the card from slot quickly, I can see the removal
message.

With your patch series, in ESDHC_CD_GPIO case the driver will have
to send MMC_SEND_STATUS (with retry) to card for knowing its presence.
This is also an unpleasant behavior comparing to the existing code.
I think we should query gpio state to know card presence for this case.

Shawn



\
 
 \ /
  Last update: 2012-11-05 14:21    [W:0.068 / U:0.392 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site