Messages in this thread | | | Date | Fri, 05 Oct 2012 07:48:01 +0200 | From | Michal Simek <> | Subject | Re: [PATCH 11/11] net: xilinx: Show csum in bootlog |
| |
On 10/04/2012 09:15 PM, Ben Hutchings wrote: > On Thu, 2012-10-04 at 20:14 +0200, Michal Simek wrote: >> Just show current setting in bootlog. > [...] >> --- a/drivers/net/ethernet/xilinx/ll_temac_main.c >> +++ b/drivers/net/ethernet/xilinx/ll_temac_main.c >> @@ -1052,12 +1052,14 @@ static int __devinit temac_of_probe(struct platform_device *op) >> /* Setup checksum offload, but default to off if not specified */ >> lp->temac_features = 0; >> p = (__be32 *)of_get_property(op->dev.of_node, "xlnx,txcsum", NULL); >> + dev_info(&op->dev, "TX_CSUM %d\n", be32_to_cpup(p)); >> if (p && be32_to_cpu(*p)) { >> lp->temac_features |= TEMAC_FEATURE_TX_CSUM; >> /* Can checksum TCP/UDP over IPv4. */ >> ndev->features |= NETIF_F_IP_CSUM; >> } >> p = (__be32 *)of_get_property(op->dev.of_node, "xlnx,rxcsum", NULL); >> + dev_info(&op->dev, "RX_CSUM %d\n", be32_to_cpup(p)); > [...] > > Is there any particular reason you think this needs to be logged by > default, rather than letting users run ethtool -k? I suggest using > dev_dbg() instead.
The reason was just to show it in the bootlog. I will check ethtool support for these drivers.
Thanks for your comments, Michal
-- Michal Simek, Ing. (M.Eng) w: www.monstr.eu p: +42-0-721842854 Maintainer of Linux kernel 2.6 Microblaze Linux - http://www.monstr.eu/fdt/ Microblaze U-BOOT custodian
| |