Messages in this thread | | | Date | Tue, 2 Oct 2012 17:28:54 -0500 | Subject | Re: Problem with mmc DMA on panda board in 3.6 | From | Robert Nelson <> |
| |
On Tue, Oct 2, 2012 at 5:24 PM, Tim Bird <tim.bird@am.sony.com> wrote: > This is an early report - I'm just checking if anyone else has seen this. > > With Linux version v3.6, my PandaBoard (OMAP-based) no longer boots. The > system appears to fail to initialize the mmc controller. > > The kernel log message of interest appears to be this: > [ 1.690002] omap_hsmmc omap_hsmmc.0: unable to obtain RX DMA engine channel 6 > > I can supply full kernel log messages and my .config if needed. > > I bisected the code and arrived at the following commit: > ------- > commit 26b88520b80695a6fa5fd95b5d97c03f4daf87e0 > Author: Russell King <rmk+kernel@arm.linux.org.uk> > Date: Fri Apr 13 12:27:37 2012 +0100 > > mmc: omap_hsmmc: remove private DMA API implementation > > Remove the private DMA API implementation from omap_hsmmc, making it > use entirely the DMA engine API. > > Tested-by: Tony Lindgren <tony@atomide.com> > Tested-by: Venkatraman S <svenkatr@ti.com> > Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk> > ------- > The board works up until this commit. > After this commit, the board hangs during boot after the message: > [ 1.852508] Waiting for root device /dev/mmcblk0p3... > (and some other USB and network messages, which I presume > are unrelated.) > > My questions are these: > Has anyone else had problems with the PandaBoard (or other OMAP) on 3.6? > Are there any related CONFIG_ variables I could change to try alternatives? > What should I try next to debug this?
Check your config, to see if these are enabled:
CONFIG_DMADEVICES=y CONFIG_DMA_OMAP=y
Regards,
-- Robert Nelson http://www.rcn-ee.com/
| |