Messages in this thread | | | Date | Mon, 15 Oct 2012 11:53:59 -0700 | From | Alexander Duyck <> | Subject | Re: [PATCH] e1000 driver RX race condition fixed |
| |
On 10/14/2012 10:19 AM, Dmitry Fleytman wrote: > There is a race condition in e1000 driver. > It enables HW receive before RX rings initalization. > In case of specific timing this may lead to host memory corruption > due to DMA write to arbitrary memory location. > Following patch fixes this issue by reordering initialization steps. > > Other Intel network drivers does not seem to have this issue. > > Dmitry Fleytman (1): > RX initialization sequence fixed - enable RX after corresponding ring > initialization only > > drivers/net/ethernet/intel/e1000/e1000_ethtool.c | 9 +++++---- > drivers/net/ethernet/intel/e1000/e1000_main.c | 18 ++++++++++++++++-- > 2 files changed, 21 insertions(+), 6 deletions(-) >
What device was it you saw this issue with? The reason why I ask is because I suspect this change should cause most of our e1000 hardware to lock up since normally if you allocate buffers and then enable Rx it will mean the ring was not updated and it will treat it as if there are no buffers available.
Thanks,
Alex
| |