lkml.org 
[lkml]   [2011]   [Nov]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: Linux 3.2-rc1
On Wed, Nov 09, 2011 at 03:40:19PM +0800, Takashi Iwai wrote:
> At Tue, 8 Nov 2011 12:23:30 -0800,
> Linus Torvalds wrote:
> >
> > Hmm, I don't know what caused this to trigger, but I'm adding both the
> > i915 people and the HDA people to the cc, and they can fight to the
> > death about this in the HDMI Thunderdome.
>
> It must be the new addition of ELD-passing code.

Yes, it's my fault.

> Fengguang, can the drm or i915 driver check whether ELD is changed or
> not? Writing ELD at each time even when unchanged confuses the audio
> side, as if the monitor is hotplugged.

It's sure possible to mask out the extra events.
I'll work out a patch tomorrow.

> > Guys: One.. Two.. Three.. FIGHT!
>
> Round two!

Three to fight!

Thanks,
Fengguang

> > On Tue, Nov 8, 2011 at 6:55 AM, Nick Bowler <nbowler@elliptictech.com> wrote:
> > >
> > > Mode switches are very noisy on an Intel G45 in 3.2-rc1:
> > >
> > >  HDMI hot plug event: Codec=3 Pin=3 Presence_Detect=1 ELD_Valid=1
> > >  HDMI status: Codec=3 Pin=3 Presence_Detect=1 ELD_Valid=1
> > >  HDMI: detected monitor W2253 at connection type HDMI
> > >  HDMI: available speakers: FL/FR
> > >  HDMI: supports coding type LPCM: channels = 2, rates = 32000 44100 48000, bits = 16 20 24
> > >
> > > These lines get printed every single switch; previously only a single
> > > line was printed once at boot (the "HDMI status" line).
> > >
> > > Cheers,
> > > --
> > > Nick Bowler, Elliptic Technologies (http://www.elliptictech.com/)
> > >
> >
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2011-11-09 13:05    [W:0.086 / U:0.104 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site