lkml.org 
[lkml]   [2010]   [Nov]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] mmci: reset voltage after power off.
On Fri, Nov 05, 2010 at 10:35:41AM +0100, Linus Walleij wrote:
> From: Ulf Hansson <ulf.hansson@stericsson.com>
>
> At power off, reset OCR mask to be the highest possible voltage
> supported for the current mmc host.
>
> This solves the re-initialization during the power up sequence.
> The voltage may have been decreased due to the card accepts a lower
> voltage than the voltage used during the initialization sequence.
> We need to reset the voltage to by the host highest possible value
> since according to specification the initialization must always be
> done at high voltage.

Surely this should already be done by:

/* If ocr is set, we use it */
if (host->ocr)
bit = ffs(host->ocr) - 1;
else
bit = fls(host->ocr_avail) - 1;

in mmc_power_up ?


\
 
 \ /
  Last update: 2010-11-07 18:19    [W:0.029 / U:0.844 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site