Messages in this thread | | | Date | Wed, 10 Sep 2008 12:36:54 -0700 | From | "Yinghai Lu" <> | Subject | Re: [19.666764] Disabling IRQ #23 |
| |
On Wed, Sep 10, 2008 at 12:06 PM, Justin Mattock <justinmattock@gmail.com> wrote: > hello; I accidently erased the original thread > appologize for starting a new one of the same, > I've been noticing this message(below) appear > every "X" amount of boot's(maybe ten or so); > normally upon booting leaving me unable > to login. > > below is dmesg of the message: > > [ 0.400075] pci 0000:00:1d.0: PCI INT A -> GSI 23 (level, low) -> IRQ 23 .. > [ 0.400104] pci 0000:00:1d.7: PCI INT A -> GSI 23 (level, low) -> IRQ 23 ... > [ 10.848404] USB Universal Host Controller Interface driver v3.0 > [ 10.857709] uhci_hcd 0000:00:1d.0: PCI INT A -> GSI 23 (level, low) -> IRQ 23 > [ 10.867186] uhci_hcd 0000:00:1d.0: setting latency timer to 64 > [ 10.876344] uhci_hcd 0000:00:1d.0: UHCI Host Controller > [ 10.885571] SELinux: initialized (dev usbfs, type usbfs), uses genfs_contexts > [ 10.894904] uhci_hcd 0000:00:1d.0: new USB bus registered, assigned > bus number 1 > [ 10.904218] uhci_hcd 0000:00:1d.0: irq 23, io base 0x00004080 > [ 10.913838] usb usb1: configuration #1 chosen from 1 choice > [ 10.923378] hub 1-0:1.0: USB hub found > [ 10.932676] hub 1-0:1.0: 2 ports detected .. > [ 12.119258] usb 2-2: configuration #1 chosen from 1 choice > [ 12.140614] ehci_hcd 0000:00:1d.7: PCI INT A -> GSI 23 (level, low) -> IRQ 23 > [ 12.149917] ehci_hcd 0000:00:1d.7: setting latency timer to 64 > [ 12.159523] ehci_hcd 0000:00:1d.7: EHCI Host Controller > [ 12.168858] ehci_hcd 0000:00:1d.7: new USB bus registered, assigned > bus number 5 > [ 12.182246] ehci_hcd 0000:00:1d.7: debug port 1 > [ 12.191574] ehci_hcd 0000:00:1d.7: cache line size of 32 is not supported > [ 12.200970] ehci_hcd 0000:00:1d.7: irq 23, io mem 0x50405400 > [ 12.250079] usb 3-2: new full speed USB device using uhci_hcd and address 2 > [ 12.270062] ehci_hcd 0000:00:1d.7: USB 2.0 started, EHCI 1.00, > driver 10 Dec 2004 > [ 12.279955] usb usb5: configuration #1 chosen from 1 choice > [ 12.289791] hub 5-0:1.0: USB hub found > [ 12.299531] hub 5-0:1.0: 8 ports detected > [ 12.309416] ath_pci: svn r3359 > [ 12.332576] hub 3-0:1.0: unable to enumerate USB device on port 2 > [ 12.356208] ACPI: SBS HC: EC = 0xf78c8000, offset = 0x20, query_bit = 0x10 > [ 12.478925] Symbol init_mm is marked as UNUSED, however this module > is using it. > [ 12.488823] This symbol will go away in the future. > [ 12.498834] Please evalute if this is the right api to use and if > it really is, submit a report the linux kernel mailinglist together > with submitting your code for inclusion.
> [ 18.821797] irq 23: nobody cared (try booting with the "irqpoll" option) > [ 18.830005] Pid: 2371, comm: swapon Tainted: P 2.6.27-rc6 #22 > [ 18.830005] [<c0151748>] __report_bad_irq+0x2e/0x6f > [ 18.830005] [<c015196f>] note_interrupt+0x1e6/0x217 > [ 18.830005] [<c0150d47>] ? handle_IRQ_event+0x2a/0x5a > [ 18.830005] [<c0151f20>] handle_fasteoi_irq+0x91/0xb6 > [ 18.830005] [<c0104ff2>] do_IRQ+0x6c/0x86 > [ 18.830005] [<c0103a6f>] common_interrupt+0x23/0x28 > [ 18.830005] [<c021007b>] ? blkdev_ioctl+0x4b0/0x719 > [ 18.830005] [<c0117347>] ? kunmap_atomic+0x4/0xa5 > [ 18.830005] [<c015fc58>] __do_fault+0x2ca/0x32a > [ 18.830005] [<c0170cf0>] ? check_bytes_and_report+0x21/0x93 > [ 18.830005] [<c0161191>] handle_mm_fault+0x2de/0x62c > [ 18.830005] [<c01635e3>] ? remove_vma+0x41/0x47 > [ 18.830005] [<c01727d0>] ? kmem_cache_free+0x80/0x96 > [ 18.830005] [<c039ebac>] do_page_fault+0x2d8/0x60c > [ 18.830005] [<c0127a95>] ? irq_exit+0x53/0x6d > [ 18.830005] [<c039e8d4>] ? do_page_fault+0x0/0x60c > [ 18.830005] [<c039d2a2>] error_code+0x72/0x78 > [ 18.830005] ======================= > [ 18.830005] handlers: > [ 18.830005] [<c02cc9fb>] (usb_hcd_irq+0x0/0x79) > [ 18.830005] [<c02cc9fb>] (usb_hcd_irq+0x0/0x79) > [ 18.830005] Disabling IRQ #23
uhci and ehci share one irq. and irq handers for them all registered....
or there is hub under that uhci again...
YH
| |