lkml.org 
[lkml]   [2008]   [May]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: MMIO and gcc re-ordering issue
Trent Piepho writes:

> On Thu, 29 May 2008, Roland Dreier wrote:
> > > The problem is that your two writel's, despite being both issued on
> > > cpu X, due to the spin lock, in your example, can end up with the
> > > first one going through NR 1 and the second one going through NR 2. If
> > > there's contention on NR 1, the write going via NR 2 may hit the PCI
> > > bridge prior to the one going via NR 1.
> >
> > Really?? I can't see how you can expect any drivers to work reliably if
> > simple code like
> >
> > writel(reg1);
> > writel(reg2);
> >
> > might end up with the write to reg2 hitting the device before the write
> > to reg1. Almost all MMIO stuff has ordering requirements and will
>
> This is how powerpc is natively (the linux accessors have extra ordering to
> not allow this of course), and there are non-Linux drivers that are written
> for this ordering model.

In fact stores to non-cacheable locations have to be kept in order,
according to the Power architecture. But you're correct in that
non-cacheable loads can in principle be reordered w.r.t. each other
and to stores.

> I think what makes altix so hard is that writes to the _same_ register may be
> be re-ordered. Re-ordering writes to the same address is much less common
> than allowing writes to different addresses to be re-ordered.

Indeed.

Paul.


\
 
 \ /
  Last update: 2008-05-30 06:19    [W:0.189 / U:0.736 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site